bear in mind the resistor will become extremely hot, you may fix on some material surface like crash bar inside the bumper
@fetos4309 Жыл бұрын
Hi thanks for adding important detail👍🏻 i did fixed to body using thermal paste and zip.
@chuckhayes8320 Жыл бұрын
I think what he’s saying is cooling fan will pull more and more current as it ages (I’ve heard usually 100k+ miles, fans begin to seize, unavoidable) more current means more heat in components, and as a safety measure a thermistor/fuse is used in the fan housing to break the circuit if temperature is too high in the components (caused by the increased current needed by the fan). This is to stop the fan burning out and potentially causing a fire. Likely it would just smoke as the coil burns out and melts some plastic but better safe than sorry!
@stefano598110 күн бұрын
Hi, I wanted to ask you if the original resistor is faulty, can I leave it in place without disconnecting it, with this modification you made? Thank you
@fetos43097 күн бұрын
@@stefano5981 hi yes don't touch old resistor atm. this is bypass video guidance, i would advise to replace for new original type part resistor located in plastic frame engine fan.
@stefano59814 күн бұрын
@@fetos4309thanks for the reply, I used two 10 awg cables but since they are large in diameter I put the yellow fastons connected to the resistor! did you solder the two terminals?
@northwest_hothatches10 ай бұрын
What size wire did you use? Or recommend
@fetos43096 ай бұрын
Hi i check for you.. just founded message...
@shedrackikwabe34936 ай бұрын
Kindly share when you have an answer for the size of wires. In my case I used 1.5mm flexible wire. Though the resistor is getting hot, I quite not sure if the size of the wire is correct or not.
@keithbaker926128 күн бұрын
Power steering problem fails after about30 minutes you turn car off but when you start up no power steering have changed steering pump but still have problem
@fetos43097 күн бұрын
@@keithbaker9261 Hi sounds like you need new power steering pump common thing with coopers, i'm just replacing mine now...