FIX Newer Briggs Carburetor Leaks

FIX Newer Briggs Carburetor Leaks - What to Check

Рет қаралды 7,894

3 жыл бұрын

These are the new design all plastic carbs briggs and stratton is putting on all new lawn mowers.
Parts:
AutoChoke Carburetor (No Red Primer Bulb on airbox) 799584
amzn.to/2A5KxdD
Regular Primer Carburetor 593261
amzn.to/2ZzHvJk
Just the White Jet assembly in the video. 592792
amzn.to/2WYdQrf
I participate in the amazon affiliate program.
Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage.

Пікірлер: 23

@rogercamp6071 3 жыл бұрын

I've taken apart and cleaned out several of these carbs but didn't know the donut piece down inside was removable, good to know 😁

@ryanravencaller 3 жыл бұрын

One of these carbs fell apart after my old neighbor hit a rock with the mower, didnt mess anything else up, but the needle fell out and was flooding the entire carb, cleaned carb, put needle back in and it was good to go again, neighbor gave me the mower to keep so I tried to sell it, no luck, by the time we had to move I saw him outside and asked him if he bought a new mower yet, he said no so I said well you can have this one for free! Told him what happened he couldn't believe it, he fired up the mower first pull and happily pushed it back home lol

@derekobidowski3301 3 жыл бұрын

these modern Briggs and Stratton engines are utter junk in addition to the carb its inside the engine that fails the plastic camshaft and timing gear when they fail the intake and exhaust valves don't work. the older L head briggs engines before the mid 1990s were best. the I/C series and the classic sprint and quattro engines. if all else fails put a Harbor Freight Predator 173cc Honda Gxv 160 clone on your mower

@butler386 3 жыл бұрын

Excellent additional information. They look simple enough. Thanks for the video.

@ocelot2234 3 жыл бұрын

Very interesting and useful thank you 😊

@bossmusic8536 3 жыл бұрын

*Hank's Garage* Good content

@ChristIsLord229 Жыл бұрын

I think this is what i needed thanks

@fillslawncare 3 жыл бұрын

Good point Hank. Although I've never took out that white donut spacer in the middle of the carb. Seems like it's pointless to remove upon cleaning? Great video! Just subscribed

@hanksgarage_ 3 жыл бұрын

Correct no reason to take them out but I’ve had them either fall out or shift on me and plus others have reported to me that their carbs were leaking after cleaning. I advised them to watch for that and recheck and it’s fixed their issues

@queenstownkid 3 жыл бұрын

thanks for the video

@weschaffin 5 ай бұрын

Very good video

@charlesoverton 6 ай бұрын

Good one.

@warrenmiller3180 Жыл бұрын

What is that white piece sticking out the side of the Carb that looks like it should have a small hose on it ?

@pcsweeney3898 Жыл бұрын

I had a carb apart, but it had the auto choke. I had trouble getting the emulsion tube back in. The donut had rotated on me. Once I did get it lined up the auto choke wouldn’t work. The butterfly stayed closed and wouldn’t open. What went wrong?

@bizzy156246 3 ай бұрын

My carb leaks gas from that little hole vent where that red/orange gasket is at. Gasket is “new” so I don’t get it. Can someone help?

@hanksgarage_ 3 ай бұрын

Stuck float probably. Pull the bowl off and make sure the float moves up and down

@garrycoleman2494 2 жыл бұрын

When I prime mine it leaks through where the filters at do u know what it could be ?

@spykes1980 Ай бұрын

I have this same issue and can't find any answers or it being covered on any of the numerous vids

@tvento 3 жыл бұрын

What do you do for a living?

@hanksgarage_ 3 жыл бұрын

Aircraft mechanic for 10+ years

@Jim-ie6uf 3 жыл бұрын

I like the carb from a design and engineering standpoint, but ... I still don’t care for them

@derekobidowski3301 3 жыл бұрын

This is what you get when you buy a modern Briggs & Stratton engine a plastic carb in addition a plastic starter cup that breaks and inside the engine along with the professional series 175 and 190cc engines a failure prone PLASTIC camshaft and timing gear. many people tossing these engines mowers and pressure washers out the trash or repowering them with a Harbor Freight Predator 173cc honda GXV 160 clone as its metal inside the engine and the carburetor. its bad what Briggs and Stratton is doing on these walk behind mower and pressure washer engines. becoming cheap in engine building.

@hanksgarage_ 3 жыл бұрын

At this point it’s only going to get worse now that they went bankrupt