Dear Mr Vinteakias, thank you very much for your video, I was just about to install this H1 flybarless in my TRex 600, and beside you there are at least 4 more people that crashed with that system, for me It´s enough, I think It´s not reliable, period.

Given how you have the RX installed and the antenna location I am not surprised.

Something that will help is getting the gps unit with the extended cord. I ran an h1 on a 700 and had the same problem. But an even better idea....I would get that controller off of you heli while you can. I found the h1 to work great until it didn’t ...... very erratic and random glitches resulting in some big crashes. I went trough two different h1 controllers and a fw450 and all had the same issues. The last and final crash I was in 3D (no gps) and it glitched out resulting in a hard impact. If I ever do gps again it will be a pixhawk. H1 is junk

s-FHSS ? If S-FHSS binding again...(turn on transmitter.....reciever on (red--> green)----> reciver (hold) button 3sec over click),,,,, If not S-FHSS, I'll have to think about it again. . It's important. With the two motor wires separated, turn on the power of the helicopter and Check the operation of the swash by tilting the aircraft left and right, back and forth.

My friend, i really think it's a bad idea taking off/landing on a surface with so much fine loose dust!? That dust will get absolutely everywhere in you Heli, the gears, the tail mechanism, the internals of motor etc etc and will act like sand paper and ruin your Heli ! Hope you sorted the problem my friend!

You are lucky,hang in there….

Good evening I can not calibrate my H1 everything done the manipulation that must do it does not validate at the end force constantly to start again how to proceed to validate it thank you

Why are you putting the heli in the dust? LOL!!

hello minimum number of channels on a radio to install the h1 thank you to you

what actually happened?. it is hard to tell

I confirm that H1 is junk, installed in a brand new TREX 470LM, I suspected soon that headspeed was too much. Result: bad wobbles in GPS mode (I tried every possible parameters adjust, expecially swash gain but no change at all) , and when I switched to 3D mode, heli went CRAZY resulting in a bad crash. I have ordered a Microbeast Ultra and ditched the H1

피치가 리버스 된듯..

low your swash gain, begin with scale style !!

Réglage a faire