great video review. Have you had any other QC issues with it? Did you ever find an avenue to buy the foam wheel as an accessory?

@@stalyun8211 Just those 2 where the button is a bit harder to fix. The battery tray has problem in the slot so if you trim some of the plastic down it'll work fine. As for the wheel upgrade, you can get the foam wheel version on Aliexpress. www.aliexpress.com/item/1005004371293939.html

@@BeaversHobby thanks for the update

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

I've been trying to get that as review unit. But if I have to buy one myself, honestly at that price I would buy Futaba 4PM Plus instead.

@@BeaversHobby you are right Beaver, the RC8X i just received latency not great, it's slower than my old sanwa Mx3FG FHSS. I am hoping to be at least the same speed to my NB4 and MT44, the RC8X unfortunately very slow in servo response.

@@oliverstoys8411 Thanks for the update. That is to be expect, They are using the same protocol as the one before so even if the processor is faster, it can only do so much before it hits the limit.

@@BeaversHobby 👍🏻

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

Unfortunately I don't have the it4. Presumably it's the same as it4s.

@@BeaversHobby thank you for the quick reply its not it used the AFHDS2 which was used only by it and a few other transmitters before they released the AFHDS2 A so different protocols but it can bind to the older receivers

@@hichamelkhoury7087 Oh I meant it would be the same when using with the 1st generation AFHDS. Take a look at the FS-GR3E on the table.

Yes, there's upgrade wheel on sale. Better still, there're shops on aliexpress that sell the G7P with foam wheel fitted as standard. www.aliexpress.com/item/1005004371293939.html

@@BeaversHobby thanks for the prompt reply. I'll check it out. I've seen the G7P online with the sponge on the wheel but I still find the standard wheel too plasticky looking. Hahahahaha...

@@BeaversHobby will you be reviewing a new transmitter, the Wfly X9 in the near future? Thanks...

@@Funkymojo75 Unfortunately I have no plan on getting the Wfly X9. Check out donaldsneffe's review. kzfaq.info/get/bejne/iNBxhpWfz9qWY6c.html

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

If you have many Radiolink receivers that you still use, another Radiolink is always a good choice. RC6GS V3 is a really robust transmitter. Flysky G7P is good if you need the micro receiver with JST-ZH plug (if you do 1/28, 1/24 for example). And if you need the servo frequency setting. Otherwise, it's not as rugged nor well-built as Radiolink and the latency is the same so I don't see much point using G7P apart from the need of 2 things I mentioned above. Another good choice is Futaba 3PV if you can get it for less than $100. It's usually $130-150. And even the 3rd party receivers are like $20+ a piece. So, not much of a budget but it has good build quality. I wouldn't recommend stretching your budget to get it. Right now Radiolink is still the best for under $100. G7P is good if you have specific needs and Futaba is excellent if you can get it for cheap.

No, but it's the same size. I also have the D1802MG but it's in another car.

@@BeaversHobby what servo are you using in this video. There is minimal wheel shake.

@@goingcrazy00 It's the standard servo from XRX DPA so, basic metal gear 5g servo. Probably stamped out of the same factory as D1802MG.

To be honest I never let the battery run out and I usually charge it after a driving session (about 4-5 hours). Anyway, I use the Ikea Ladda 2450mAh and it still has a lot left after each session.

G7P is better. It has better performance, better receivers and better battery compatibility. If you will also use it with a car with 4 wheel steering, G7P also has a dedicated mixing mode for it.

Unfortunately there's no internal gyro. But it's great for 1/28 whether drifting or touring. For RWD drift we always use external gyro so there's not going to be a problem either way.

@@BeaversHobby Awesome I’m looking into getting a transmitter/radio for my 1/28 micro cars. Have a mini Z and k989 cars also. Do u know what part number to use for a micro 1/28 transmitter receiver? What gyro also do u recommend. Thanks…

@@808DC2R For 1/28 the receiver is FlySky FS-R4M. IT will come with JST-ZH plug ready for 1/28 electronics from major brands like Atomic, GL, Furitek, etc. As for the gyro, the best one for the size is AGF GY04M V3 or AFRC GYS-2 V3. There are others with the same case and board, basically they are the same gyro but with different branding.

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

Unfortunately no. It's the new protocol and doesn't have backward compatibility.

@@BeaversHobby that’s so sad, thank you for the information!

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

It depends on what you want to do for touring or racing then get a RWD that has 98mm wheelbase like McLaren P1 or Audi R8. For drifting get the AWD with 90 or 94mm wheelbase like the new Supra, Skyline, AE86 or Subaru Impreza with bodykit.

@@BeaversHobby cheers dude

Have u seen rcunextuesday live stream on wensday evening uk time

@@lucionjay5376 No...

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

I saw yours just when I updated this on the pinned comment. Yes, I also got the self-reset problem with just a light tap on the transmitter.

That was the amazon batteries he was using. For 5 dollars more you can include the 2s lipo battery or any other cells work well. It's a better feeling radio than the 5 - also they all seem to come with foam wheels now.

@@mikewilson6019 If it comes with foam wheel now it's fantastic! When used with lipo or anything that plugs into the JST under, there's no random restart anymore so the problem is clearly in the battery compartment.

U can follow us to get more information about FlySky products: facebook: flysky rc model instagram: flyskyrc_official Thanks!

There's a shop in Aliexpress that sells the foam wheel version. www.aliexpress.com/item/1005004371293939.html

FS-R4M

Is it support gyro?

@@user-hq6ec1fe6c Yes. You can use ant gyro then assign a knob or a rocker to channel 3 to adjust gyro gain.