No video
Flysky Noble: FGr4B RX with voltage sensor - setup
Рет қаралды 3,753
Күн бұрынFlysky FGr4B receiver: www.banggood.c...
Flysky Noble NB4: www.banggood.c...
Flysky Nobe Pro: www.banggood.c...
@therealpb674 2 жыл бұрын
So much to learn. Building a trx4 sport and picking up one of these transmitters, you convinced me. It would be great to see a video of a full set up on your top recommendations, setting up one of the LC80s, as my esc (battery connector) keep breaking and I just messed up the servo (electronics sold out at amain!). Appreciate your videos!
@alex_455 Жыл бұрын
good video
@JoannaJedrzejczyksForehead 3 ай бұрын
Where can I buy those bvd wires? Is there a model number for them?
@donaldsneffe 3 ай бұрын
They come with the receiver. But you can easily make those yourself, simple servo plug (Dupont)
@Zstreetfighter18 Жыл бұрын
Hallo, hat der Empfänger einen Gyro verbaut?
@donaldsneffe Жыл бұрын
Nein
@CarlosDelaoGunEngraver Жыл бұрын
can the battery meter plugs just be soldered to the xt 60 or 90, in other words so I dont have to be connecting it to the balance port all the time
@albertkelly7129 6 ай бұрын
yes but only connect the positive lead to the esc red wire
@Savvrawr 4 ай бұрын
@@albertkelly7129 then where does the negative go??
@albertkelly7129 4 ай бұрын
@@Savvrawr no where, just tape it closed and heatshrink over it
@albertkelly7129 4 ай бұрын
@@Savvrawr note im only talking about the included BVD cable. If you are using the stand alone voltage sensor then you connect both positive and negative
@ignasanchezl Жыл бұрын
Do you know what the voltage range is for the BVD on these recievers? On the airplane recievers they actually mention some go up to 70V but there's no info on the manual for these!
@donaldsneffe Жыл бұрын
100 V? Did not test - but check: www.flysky-cn.com/cvt01-canshu
@tomtmrt9197 2 ай бұрын
Hello. Batterie 4s it ok?
@abdullajuma4068 Жыл бұрын
Can I measure a 6s battery in a voltmeter?
@donaldsneffe Жыл бұрын
With a voltmeter? Normally yes, 6s is 25.2 V, every "normal" voltmeter can do this.
DutchRC Adventures
Рет қаралды 3,2 М.
How to bind an NB4 RX w/bind button & update firmware, set up voltage alarm with the internal sensor
Metal Gear RC
Рет қаралды 1,7 М.
Beaver's Hobby
Рет қаралды 22 М.