FLYWING lets talk ESC
Рет қаралды 744
Жыл бұрынFLYWING lets talk ESC
@iriquiosgunship 11 ай бұрын
Flywing customer service was useless for me. I have the same problem. Thank you for sharing.
@AlexBongRCFunLand Жыл бұрын
Roy, the mosfet used is 30V 78A. PCB printing doesnt reflect the actual power.😊
@frederickgrassie3383 Жыл бұрын
Cruz, thank you. Plug was damaged by me when I used needle nose plyers to pull them apart.
@CRUZROYHelicopters Жыл бұрын
you noticed fgbfstfgbfst7294 new to youtube is explaining why a new v3 esc has old label, i would recomend not flying 6s till i investigate, esc's are hard to get and expensive when there going to pop on a blade strike or small crash
@fgbfstfgbfst7294 Жыл бұрын
Because at the beginning of V2 design, the version number was initially defined as 4S 30+15A. But later on, the MOS and board thickness were changed to increase to 60A 4S, and then changed to 6S 60A. You can check the specific MOS chip model, which I remember correctly should be 70A MOS。
@CRUZROYHelicopters Жыл бұрын
this is a new esc, from v3, so you saying you did not change label on PCB so it still says 30a15a4s2in1v1.4 ??????? so v4 version has same board, i will check fets on this board and check back
Immersed
Рет қаралды 94 МЛН
How To Home
Рет қаралды 10 МЛН
Defolt Movies
Рет қаралды 6 МЛН