Ford 3000 engine rebuild
Рет қаралды 8,854
2 жыл бұрынWatch here Fords 3000 cold start • ford 3000 cold start
Watch here Ford 3000 first drive after rebuild • Ford 3000 first drive ...
Parts replaced.
New radiator, fan shroud, Generator, starter, wiring harness, dash cluster, ignition switch, kill cable, water pump, nose cone, grille, headlights, front axle bushing and pin, steering wheel, seat, steering box thrust bearings, all four tie rod ends.
All three pistons were replaced, of course all new rings and connecting rod bearings. Head gasket, valve cover gasket, oil pan gasket, injector seals and many other seals and gaskets were replaced and a 4DLT battery.
@donttreadonme4355 2 жыл бұрын
check description for follow up videos.
@richardross7219 Жыл бұрын
Just found this. First off I disagree with you that its a nice tractor. As long as you do a thorough rebuild, it will be a great tractor. At the point where you are, do a frame out rebuild, and replace the clutch. Good Luck, Rick
@donttreadonme4355 Жыл бұрын
I would agree if the clutch was 40 years old, but it wasn't. This tractor had a complete rebuild back in the early 2000s and the clutch was replaced. This tractor was used after the 1st rebuild mainly for mowing pasture. Since I have done a inframe rebuild this tractor has worked very well. You can watch me driving for the first time here kzfaq.infoSF7NYfTA5xs?feature=share
@richardross7219 Жыл бұрын
@@donttreadonme4355 Good. I need to split my 1973 2000 and replace the clutch but, with the loader its such a pain. I've been rebuilding machines since the late 1960s and learned that when I had something mostly apart it was usually a good idea to just do the entire thing. Good Luck, Rick
@donttreadonme4355 Жыл бұрын
@@richardross7219 If it's worth doing, do it right.
Josh Archer Vlogs
Рет қаралды 823
Dan Gingell and Rachel Gingell
Рет қаралды 250 М.
Der kleine DreXler
Рет қаралды 30 М.
Dan Gingell and Rachel Gingell
Рет қаралды 92 М.
ЕвгенБро
Рет қаралды 260 М.
ARM Hov
Рет қаралды 617 М.