It's not a jubilee either. 1954 would be the NAA. Jubilee was 1953 model only.

@@roncrawford7128 The Golden Jubilee with that insignia on the nose was only made in 1953. After that like you say the NAA but a lot of folks still called them a Jube but just not the Golden Jube.

Nice find! Lots of good parts out of Dennis Carpenter and even Tractor Supply company if you need any.

Eh, you don't get much snow down there. It will probably have close to no rust. How'd it go?

Does yours have the Sherman 12 speed?

Obrigado!

Johnson Simões is

Aqui no Brasil tem alguns deste modelo.

estou negociando 1951 pretendo coloca-lo para funcionar

No, but recently we did upgrade to a 12v system. Completely changed out the internals on the generator, reg/rec, points, and battery. The thing starts up in under a second now!

+Ben Stah (bs495) The 3 point hitch upper arms came off fairly easy. Remove one side retainer (2 bolts and a washer) then put a pry-bar between the arm and the 3-point housing and pry it off slowly. Once it moves about 1/2 an inch, you can get a large drift punch and hit it off with a hammer. Then you can do the other side. If it's stubborn, you've got to pull out the blue-torch and get some heat into it... then douse it with PB blaster and let it sit for a few hours. It'll break loose.

Corrected in the description.

Carburetor, or it could be the coil giving you a weak spark. Try cleaning the points, and see if it gets better, if not, probably the coil.

Can also be a stuck valve. I have one I’m working on right now with a stuck intake valve. Backfiring through the carb

Vinegar and a hand-full of bolts.

It's a 52 - I mis spoke. I did correct it in the description when I uploaded the video.

Ford Red, Tractor Supply Co.

Uh, Tractor Supply will sell you any red paint and tell you to go find a Ford tractor and just paint it. Been there...done that!

It's called "Ford Light Gray" it should be at your local Tractor Supply, or paint supplier in a single stage.

@@AimlessMoto THANK YOU!

Yea... I addressed that in the description and comments. Thanks for watching.

Stuff from Dennis Carpenter.

Walker Outdoors tractor supply co. You can get everything you need.... if not there, Dennis Carpenter... but their customer service is terrible.

Walker Outdoors check around San Jose California for old tractor parts. You might find somebody online selling parts.

Ebay

You can find 9N and 8N repair manuals on eBay and Amazon for $20-30. They're honestly so simple to work on you don't need it. The only things a manual is good for is to rebuild the 3 point hitch/draft control under the seat and rebuilding the motor. Tractor Supply company will sell most of the larger things you'll need, exhaust, manifolds, nuts and bolts, filters, gaskets, lables, even paint. I suggest subscribing or picking up some copies of "N News". It's a very reliable source for all things "Ford" tractor. Good luck!

Thank you for your very quick response. I will look up N news !!!

It's a 52'. I'll get back to you with the serial number, but it checks out to be a 52'. The 53' Jubilee motor is completely different from the 8N, it's an over-head valve motor and all of them (600/800etc) were side-mount distributors. This 52' is a side-mount distributor... YES, it goes into the front cover, but it is considered a side-mount... if it were a front-mount, you wouldn't be able to see it just by looking at the tractor, you'd have to get up under the side and follow the plug wires up to the front of the engine behind the fan.

Jerry Kilby yes I have a 1952 the last year the 8N was in production. I also have the 1953 Jubilee which replaced the 8N. Then I have the 600 series then I have an 800 series. Sorry, but this is a much earlier Ford.

That is the side mount distributor.

Clearly stated in the pin comment and the description... I know.

Clearly stated in the video and description and pin-comment... I know.

Actually it’s 1947 through 1962

Yea... working on that.

Yeah, my mistake. Thanks. I did edit the description to address that when I uploaded the video. Thanks for watching.

Ken you're a douchebag.

It's a 52. I mis-spoke.