Ford F150 Starter Replacement - No crank No Start Fixed!

No video

Ford F150 Starter Replacement - No crank No Start Fixed!

Рет қаралды 21,810

Guy of All Trades

Күн бұрын

Пікірлер: 14

@keven6373 Ай бұрын

Thank you! I have a 2018 F-150 STX and this video really helped me replace my starter myself. My original starter would drag at first start (like the battery was dying) and after a short drive to the store it would not start till after a 45 min to 60 min cool down. Ford Motorcraft really got the original starter wrong, my truck had been doing this since 60K miles.

@theguyofalltrades Ай бұрын

Glad to help!

@kz3048 6 ай бұрын

Great Video thank you... question... where is the ground wire?

@theguyofalltrades 6 ай бұрын

Thanks! The ground is the case of the starter. There is a ground lead to the engine block and chassis from the battery

@jayclark5912 5 ай бұрын

Looks like I have the same problem. That 12 volt field wire looks pretty bad on my 2017 f150. I know the battery and relay are good.

@theguyofalltrades 4 ай бұрын

That’ll do it. Haven’t had any issues since I replaced it. I used a duralast from autozone since I was in a pinch too. I was reluctant to not use a ford part but it’s been fine.

@calebroller7504 19 күн бұрын

How did you reach the top bolt on the starter ?and will it be the same for a 2015

@theguyofalltrades 19 күн бұрын

It should be almost identical on the 2015. I think 2015-2022 are all the same. You may need an extension or universal for the top bolt. Bottom bolt definitely needed a deep socket

@jimmynoack420 Ай бұрын

I have a 2010 5.4 and changing the starter on this model is a nightmare it's extremely tough getting the top bolt and if it's rusted it's almost impossible

@theguyofalltrades Ай бұрын

Definitely tight in there

@MEPS003 3 ай бұрын

Not having any luck with my '17 and I have cussed ALOT!!!

@theguyofalltrades 3 ай бұрын

There’s definitely cussing involved. What issues are you having?

@MEPS003 3 ай бұрын

I ended up getting it after persuading it with a pry bar.

@theguyofalltrades 3 ай бұрын

I can imagine if there was any corrosion it might be a pain the break loose. Hardest part for me was getting it out from behind the frame cross member