This time I am folding up the rear wall panel and getting into place
Пікірлер: 14
@banggrod18 күн бұрын
This is great. Thank you Steve.
@Steves4WDShed-uz6zc14 күн бұрын
Thank you, glad to hear that you’re enjoying it
@nigelmorgan34496 күн бұрын
Hi bud maybe you should by yourself a bevel gauge easy to use and you can set your angles you can by them from your local hard wear
@Steves4WDShed-uz6zc4 күн бұрын
Thanks mate, I will look at them. I was only bending to 45 degrees so I wasn’t too worried about it
@pilchard200021 күн бұрын
Might have to respray the boat .
@erkalot21 күн бұрын
im glad i wasnt the only one thinking that
@Steves4WDShed-uz6zc20 күн бұрын
I was thinking the same thing. The boat does have some corrosion under the paint so I will be stripping the paint, repairing it then repainting it after I finish the ute chop
@ChaseTheWeekend20 күн бұрын
Nice project! Subscribed. Is that a Windsor on the floor and will that be going in the Mav? Keen to see more.
@Steves4WDShed-uz6zc19 күн бұрын
Cheers, it is a Windsor but not for this car. This is getting a BMW M57 diesel
@ChaseTheWeekend19 күн бұрын
@@Steves4WDShed-uz6zc Oh sweet! I'll be following along for sure.
@mattluszczak809517 күн бұрын
Whats with these m57 om606 swaps. Theyve been doing them into landies in the uk for years
@79series17 күн бұрын
Yeah but landies are shit
@mattluszczak809517 күн бұрын
@@79series have you owned one ?
@Steves4WDShed-uz6zc14 күн бұрын
They have been doing the M57 here in Australia for a few years now, they are getting more popular here as time goes by. I would love the om606, but they are rare here