How to assemble a Ford hydraulically assisted steering rack. Explanatory tutorial of the assembly process. The explanation begins by verifying the state of the teeth, which must all be uniform, then the state of the cylinder corresponding to the part of the pinion is verified, then the lower retainer of the pinion is installed, the shaft regulator and proceed to install the inner seal of the shaft, but for this the area of ​​the teeth, the lower bearing of the pinion, is covered with adhesive tape, the pinion is lubricated and installed in its housing, then the upper bearing of the pinion is placed, as well as the upper seal of the pinion, later the retainer insurance, in the lower part of the pinion the nut and cover are placed and adjusted. Next, the seal and oring are installed on the shaft stem, the threaded part of the shaft is covered with tape to install the seal, then the ring and insurance. Then the spring, cover and nut are installed, then the play is adjusted until the play is reduced and the nut is adjusted, then the axle and the steering racks are lubricated, then the security seals are placed, finally the cover of the regulator.
Visit: hidraulicaveloz.blogspot.com/
More information: hidraulicaveloz@gmail.com
Address: Union 528 Trujillo Peru
Visit: yovelpe.blogspot.com/