Where can you find the rebuild kit? I keep searching but can’t find a specific one for my cbr 600 09 I found other kits
@pepperjackshack2439 Жыл бұрын
just say to make sure that nut on the top of the damper, the thing the cap screws onto nut is 10.8mm down from the top of the threads. When you service the cap, the nut tends to works its way down the threads and if you dont check this, reinstalling the cap you will find the rebound flat head screw only goes 1.5 turns in. This is not mentioned in the service manual from what i can find. Damper nut threaded length = 10.8mm from the top of the damper rod.
@PostednToasted Жыл бұрын
Does abs make a difference? I would have to remove my abs sensor to get my right fork out. Is there anything different in this process or will it all go back to normal after I rebuild and install
@wilberjesusmartinezraygoza8089 Жыл бұрын
Hi, I’ve a question, what’s the fork oil measure for each one fork?
@Wavy_G1 Жыл бұрын
Just wondering how would i check oil level when refilling if spring is already in.. would measuring it out be accurate enough since you didn't take apart the lower or do you compensate a little less oil
@Wavy_G1 Жыл бұрын
Let me know how much oil i need i have the same bike but mines a 07
@sputnikl727Ай бұрын
You dont need to spring compressor tool?
@DAAN_MUSIC Жыл бұрын
I am going to try this method as I wont need the spring compressor tool. Thanks 😁👌
@sputnikl727Ай бұрын
How did it go?
@DAAN_MUSICАй бұрын
@@sputnikl727 went fine! Just take care with the screwdrivers to not scratch the fork when taking out the circlip/rings.
@sputnikl727Ай бұрын
@@DAAN_MUSIC you just unscrew the top nut and bottom and lift out the entire inside spring assembly? How do you get the oil back in and the level?
@DAAN_MUSICАй бұрын
@@sputnikl727 I used a big *ss syringe type of thing to do the oil. And instead of measuring the exact level I just got rid of all the old oil and put in the exact amount the maintenance manual specifies.
@leshirner70753 ай бұрын
How much oil?
@stevepooran2240 Жыл бұрын
But you never oiled the bushes and sliders and also you never bleeed the air out of the damper rod
@drewcecato22111 ай бұрын
😂
@joelgrandbois9327Ай бұрын
Whatever you do do not take your bike to this guy. Your forks are going to be uneven because the system was never bled. You have to take the spring off to bleed the inner damper. This is total blow and go. Probably charge $250 and didn't even do a thorough job