If this vid isn't at or near the top of the list of 'Fusio360-101 Intro for Newbies' videos at the -Autodesk- site, it should be. Rule #1 Rocks!!!
@Markevans363015 ай бұрын
Well this modified my understanding of top-down and bottom-up, at least when I hear it from Autodesk. Something that really helps if you use several sketches to make a single part is to simply name your sketches. So much easier than seven numbered sketches. That and of course rule #1 so your not hunting through 34 sketches instead of seven.
@gamergoohoo Жыл бұрын
3:52 did you mean "features made are contained fully in this assembly*"????