Thanks for the videos, I just purchased parts from open builds to get my k40 fixed up after a couple years of being broke down. I'll be following along hoping mine will be as nice as yours.
@denniskramer97882 жыл бұрын
Very nice...where are the adjustable bed stl s
@user-dm2no4vz1p3 жыл бұрын
I am your fan from Russia, I am very much looking forward to your new videos, you are great
@cullensaquarium3 жыл бұрын
Hey Bill, these videos have been fantastic! I feel your pain with the sausages, same boat haha
@sotm2 Жыл бұрын
How did you connect the wires to the JST female connects? They are solder pins and won't that melt the plasric socket??
@MicroRotors Жыл бұрын
Yes, if your not carful, they will melt. A very hot iron with a small tip and quickly solder. Use a mating plug with alligator clip on the pin being soldered as a heat sink. It takes practice and I did burn my share of them.
@snydergc2 жыл бұрын
Do you have links for the male/female connectors for the steppers, 12v, etc.?
@torstenpentz875 Жыл бұрын
did you attach the wooden build plate to the old aluminium bottom plate or does it sit just on top of it??
@sotm2 Жыл бұрын
Do you have a link for the Z table build? BTW Nice job, I have a similar build on-going but am having trouble between the Cohesion board and Lightburn. What software are you using to operate the cutter? I mounted the Y stepper in the middle of the back using two half shafts, eliminated the 3D printed drive pulley that way.
@willexi11903 жыл бұрын
Been waiting on this Bill! 👍
@down_n_dirty6723 Жыл бұрын
How hard was it to align the mirrors with each other
@MicroRotors Жыл бұрын
very easy, start with the tube being aligned.
@e.kostadinidis3 жыл бұрын
ΜΠΡΑΒΟ ΠΟΛΥ ΚΑΛΟ!!!! ΑΑΑΑ+++++++ ΞΕΚΙΝΗΣΑ ΝΑ ΤΟ ΦΤΙΑΧΝΩ ΚΑΙ ΤΟ ΔΙΚΟ ΜΟΥ!!!!!
@DavidR8 Жыл бұрын
Thanks Bill, what Cloudray head is that?
@MicroRotors Жыл бұрын
From Amazon, ... Cloudray K Series Set Head & 1st 2nd Mirror Mounts D20 FL50.8 for 2030 4060 K40 Co2 Engraving Cutting Machine
@DavidR8 Жыл бұрын
@@MicroRotors Thanks!
@waynesexton92343 жыл бұрын
It’s a really nice clean conversion, I have printed the first group of files, I have the aluminium extrusion, gears, wheels, bolts and nuts etc to start the build but think I will get the cloud ray mirror holder set first before pulling out the k40 gantry, I will just get everything done up to that point, your Frankie 40 looks a lot more solid and professional than the original and from the videos sounds a lot quieter , I will also be interested to know if the cohesion upgrade is worth the dollars spent, freight to Australia is $100usd before even purchasing the board, I have been looking into the meerkat 40 software, currently using k40 whisper, did you try the meerkat 40 software?