spirograph mentioned! ! ! . my Dad had a glorious set. so many parts.

Interesting - I have no problem reading everything. Thanks for the preview of the new features!

FreeCAD is getting better and better. I'm still using Fusion 360 but I'm hoping to switch with the next release (1.0)

Please check your recording settings. It looks like it was scaled down to 480p and/or compressed to much because the text is very difficult to read.

This is fantastic

Here is an old one for you. Draw two independent boxes in sketcher. Now join them them to each other at one corner using the "coincident constraint". Now assume that sometime later(after adding many other objects and constraints you decide you want to detach the boxes by removing that coincident constraint. How do you find it without hunting and pecking by selecting lines to figure out which one it is? BTW: I submitted and issue for this in FreeCAD years ago and although there was discussion it never seemed to be resolved from what I can see

I cannot read anything.