Watching such craftsmanship is a pleasure to behold

Man, this is just beautiful. The attention to detail is fantastic!

That this channel haven't picked up momentum yet, is unbelievable!! Should be 100K+ by now... Super cool and qualitative content!

It's getting close Dan. Looks great. The interior and lights really look really clean.

Looking good Dan, I was more nervous watching the headlight covers going in! Looking forward to the next one!

Fascinating video Dan, thanks again. Great skills.

OMG that looks truly stunning, great work buddy 👍😎

Fantastic attention to detail as always Dan

fantastic work again Dan, looking forward to the transmission fix. take care!!

been missing this build

Thanks for the update, I've missed you! As mentioned below, your attentian to detail is top notch and keeps me wanting to watch, Oh and the car is a big attraction too! British Grand Prix Quali is about to start. Daughter & grandson are there and it's raining.

GO DAN GO!!! Cheers from Italy!!!

Off the top of my head, I think that's a great idea, because that area will see flex.

I love your attention to detail. This will set apart your build against others. Thanks for sharing your journey.

Tip Unless it’s a track only car you will want to basically close off those fender vents. As cool as they look they’re an absolute nightmare on road cars especially in the wet with an open cockpit. At the very least you should fit a deflection shield to duct the road grim away from them so it doesn’t spray out. BUT It’s looking really good 👍 Another tip The ordinary masking tape it is really terrible for fine work and the glue is horrible to get off if it’s left on for more than a few days. So it pays to use the expensive coloured stuff as it bends better, removes easier and the glue usually doesn’t turn into stone.

Your Dremel tool skills are the best I’ve ever seen. Those lines are amazingly straight.

I love everything about this project except the occasional patriots gear making an appearance. 😂 Great work Dan

27:40 looks like NFS video game intro LOL Great work!!

Powder coating the headlight gloss black was a great idea, it really looks great!

That was a great idea to make the gap even around the headlights. Very clean!

Hi Dan great to see you back have missed your videos cars coming along great this would have been my dream build but at 71 to old now look forward to the next one Kind Regards from Liverpool England.

You could use a straight edge and wood router to machine the front clam to recess the wheel-well vents

Car is looking amazing but you need to get those vents recessed, they look so much better when they are. Use a Dremel sanding bit and take your time.

Wise not recessing. I know all too well the "pucker" moments. On my Hurricane Cobra I angled the dash slightly to mount a heater (mounted center so I could use a glove box) so now I have to trim the cowl very slightly.

Love the carbon on black! Would you be able to swap the low beams for HID projectors? I don't mind LED, but I'm a sucker for good ol Xenon.

I'm a big fan of front clam.

Dan it has been a minute. Looking soo sharp, You must be very excited to get her on the road? Hope to see you at the Newington Mall I will be bring our 67 ElCamino, weather permitting.

Can you change those centre buttons please?! Have D on the left, P in the middle and R to the right?? 🙏😝

all good, but why high beams are outside, and low beams on inside?

What do you think about under mount fender vents?