Fuel Pump Test And Injector Pulse Toyota 22RE

No video

Fuel Pump Test And Injector Pulse Toyota 22RE

Рет қаралды 29,167

Dragsters & Transmissions YouTube Channel

2 жыл бұрын

#noidlight
#electronic
#fuelinjection
#pump
#89toyotatruck
#22RE

Пікірлер: 30

@hoveasy Ай бұрын

Good video, helpful

@robertcapozzi2934 Жыл бұрын

Thanks this will help me diagnose tonight driving along and truck cut out wouldn't start 237,000 miles been running great,I'll replace fuel filter and try your method

@bobandre53 6 ай бұрын

I have the same truck. In order to start in the cold you have to pump the key instead of holding it down. What that does is squirt extra fuel from the cold start injector every time you turn the key. Everything's working you just need more fuel so you do that by turning the key on and off a bunch of times to get it to finally bounce over the colder it is the more fuel you'll need

@shannonbartley4898 2 жыл бұрын

Thanks this helped me out

@DonRosa949 Жыл бұрын

Hola, no he podido arrancar mi Hilux 22RE durante casi 2 años. Pensé que era la bomba y ni era, hice trabajar el relé y no enciende. Revisé las bujias y están bien. Le ingresé combustible de manera directa al cuerpo de aceleracion y arranca por unos segundos.

@dragsterstransmissions Жыл бұрын

Thanks for the comment but I don't understand spanish

@hhuntercc2617 10 ай бұрын

Y ya pudiste arreglar el problema?

@DonRosa949 10 ай бұрын

@@hhuntercc2617 no... ahí está la pobre... una pena.

@LeoNardo-so2sx Ай бұрын

Does the toyota have a fuel pump relay that can be checked

@heathennomad3357 2 ай бұрын

You check fuel pressure through the cold injection port with banjo adapter

@michaelcarson2572 2 ай бұрын

i failed the first test any ideas ? but pump primes with jumper from B+ to fp. replaced opening relay and main relay. still cranks no start , runs on starting fluid. i,m replacing fuel filter.. 87 4 runner sr5 wouldn't start after filling gas tank.

@mrowandoor Жыл бұрын

Hey brother I am having the exact same problem with mine I changed the mass airflow sensor, and the open circuit relay, and the fuel pump. It will run on starting fluid while I spray it but as soon as I stop spraying it dies. Any suggestions?

@dragsterstransmissions Жыл бұрын

@OSPNlive under hood beside the fuse/relay box is the diagnostic port on passenger fender. Open it locate Fp and B+ and put in a jumper wire. Turn key on but do not try and start. If the fuel pump is working at all you should hear it. If not check wires all the way to fuel tank and still may have to remove tank. Keep me posted and thanks for watching

@aidanrobbins1619 Жыл бұрын

Yeah mine did that and to get it going hit the bottom of the gas tank with a block of wood or something while somebody cranks it and it will start most of the time this won’t fix the problem but it can help you get it home or something

@alessandroarellano1752 Жыл бұрын

No injector pulse on my 93, any suggestions?

@ciskokidd5980 Жыл бұрын

And, in part 2, what did you find out? Thanks for this one..

@dragsterstransmissions Жыл бұрын

@Cisko Kidd on that one I had to remove the fuel tank and replace a 2" piece of fuel hose at the fuel pump

@ciskokidd5980 Жыл бұрын

@@dragsterstransmissions Ouch, plugged or split? Lots of work for a small piece of rubber. I've stopped dropping tanks, much rather pull the bed. Dionosticly speaking I've exhausted most reasons/steps for a no-start. Can't determine if the fuel regulator acts as a failure point, really don't want to drop the fuel filter, ( brand new) Have power to pump, no humm or pump run sounds, nothing at the bango, e.t.c Thanks for the reply .

@dragsterstransmissions Жыл бұрын

@@ciskokidd5980 fuel pump only cuts on during engine cranking

@ciskokidd5980 Жыл бұрын

@@dragsterstransmissions Thanks

@ryantinti6088 2 жыл бұрын

Great tips. Did you find your issue?

@dragsterstransmissions 2 жыл бұрын

4 years ago I installed the complete fuel pump assembly that the truck owner bought from Amazon. Cheapest I'm sure. So fast forward to this video I ended up dropping the fuel tank removing the pump assembly to replace the rubber hose that connects the pump to the assembly. Hose is 1.5" long and it was of poor quality