Supplies:
Fuse Tool
Page protector
Chipboard Alphabet
Sequins or glitter
Scissors
Small hole punch and twine
Directions:
1. Plug in fuse tool and allow to heat for 15 minutes.
2. Use chipboard letter and seal around it with fuse tool being sure to NOT seal around the top of your initial. (this will be the opening for you to add glitter/sequins)
3. Trim around the outside edge of your initial being sure to leave about an inch above the top of your initial to make sequin filling easier.
4. Fill initial with glitter/sequins using tooth pick or skewer to gently move sequins to the bottom of your initial.
5. When initial is filled place chipboard letter back onto the initial lining it up with previously sealed edges and now use fuse tool to seal the remaining open edge.
6. Gently lift from work surface and cut out top edge of initial just beyond your fused edge.
Same technique can be used with any shape!