Fusion 360 For Woodworking: Creating A Mortise & Tenon Joint

Рет қаралды 4,740

5 жыл бұрын

Todays Fusion 360 For Woodworking video I talk about creating a mortise & tenon joint. There are definitely more than a few ways to create one inside of fusion but this is how I would accomplish it. Id love to hear your feedback since I am still very green to fusion.
visit insidethekerf.com

Пікірлер: 9

@EliasMakes 4 жыл бұрын

Great tutorial, you can also use "Assemble" "Joint" to join the 2 component instead of align 👍 i think that tutorials for woodworking are as important, as the tutorials for using the shop tools. Keep up the good work.

@jordanbecker1 5 жыл бұрын

This was very helpful, thank you. I'm having trouble modeling up an angled mortis and tenon. Would you be able to do a video on that? Example would be a bar stool or coffee table where the legs come down at a slight outward angle, instead of 90 degrees. Thanks!

@insidethekerf4731 5 жыл бұрын

My apologies there Jordan I missed your comment somehow. Yes, I can make a video on how to do that. Although in my delay in getting a response are you still needing to know how to accomplish this? -Scott

@jordanbecker1 5 жыл бұрын

@@insidethekerf4731 no problem Scott, yes I'd still very much like a video on it. I've been able to figure or a way to do it, but I'm sure that is not the most efficient or accurate way. Thanks!

@insidethekerf4731 5 жыл бұрын

@@jordanbecker1 kzfaq.info/get/bejne/mbyGlqyZqMvVf4U.html Here you go my friend, sorry on the delay. I hope this helps you!

@angusross-thomson1288 4 жыл бұрын

As an alternative, you could use the Modify/Combine option to use the tenon to cut a mortise hole as shown here kzfaq.info/get/bejne/eLmomM-c0Za8oI0.html. Saves the alignment issues.

@insidethekerf4731 4 жыл бұрын

Totally agree. I made this video a while back and have learned a lot in Fusion since then. Ill work on a updated version of this topic!