Fusion 360 - NO MORE CAM Tool Marks

No video

Fusion 360 - NO MORE CAM Tool Marks - Ask LarsLive

Рет қаралды 4,241

Күн бұрын

NO MORE CAM Tool Marks is a snippet of Sunday's Ask LarsLive. You Can watch the full episode here:
• Ask LarsLive Fusion 36...
(The advice in my videos are my own and are not intended to represent the views of my wife, children or employer)
My email:
contact@larschristensen.org
Want to learn more about Fusion 360? Check out this link:
autode.sk/2rXApL2
Free CNC Handbook:
www.larschrist...
LET'S CONNECT:
/ lars_cadcam
/ mrlarschristensen
/ cadcamstuff
MY SITE:
www.larschrist...

Пікірлер: 10

@bigmanblackt-shirt8506 5 жыл бұрын

I used to have those same vertical marks, it happened everywhere I used tabs on baltic birch plywood. I finally was told by someone to switch from Climb milling for that 2D Contour cut to Conventional milling. I did and no more tool marks!

@Audio_Simon 5 жыл бұрын

I've always called these 'whitness marks'. Due to the browning of the wood I'd say the tool is dwelling there. Are you plunging the tool on the spot? Need to use a lead in and lead out and ramp the Z during those maneuvers.

@qcnck2776 5 жыл бұрын

Nice tip about the corner mode, Lars. Learned something new, again!

@danl.4743 5 жыл бұрын

I also realized that changing the lead in angle from 90 degrees to 0 degrees helps moving in smoothly into the material.

@cliff4377 5 жыл бұрын

Routers flex, so give some low angle lead for the tool to develop full pressure before the actual finish pass is in a critical noticed spot.

@TommyBoy7Heads 5 жыл бұрын

I noticed something with the lead-in moves, specifically when you have "multiple finishing passes" checked. The lead-in moves are an arc on only the initial pass. Entry point on subsequent passes is just a series of short G01 moves. Something to keep in mind if you definitely want an arc move on your finishing lead-in.

@timshig2226 4 жыл бұрын

Awsome Lars. Thanks!

@MCEngineeringInc 5 жыл бұрын

Wish there was a way to add corner radii in the CAM side without modifying the model

@cadcamstuff 5 жыл бұрын

You could use the new derive function from your original model. BUT, don’t tell anyone you heard it from me...I saw something from the development team that could answer your prayers 🤫😊 patience

@Duraltia 5 жыл бұрын

Usually, or rather most notably, had this problem when using Tabs but solved it by using a combination of _Multiple Finishing Passes, Repeat Finishing Pass_ and _Finish only at Final Depth_ like in this video kzfaq.info/get/bejne/rrGhgZCCmJjanKM.html where I did a Grill Table for my Mom.