The arms are currently not working due to the fact their pieces are snapped and need 3D printed. Working on that now. This thing was a pain in the ass to repair. The square shaft is a terrible design with a chunk of teeth intentionally missing. Problem is that makes it super easy for a tooth to snap and then boom no more head dropping. One of the arm pieces was stuck on so bad I bent the 1/4 metal shaft removing it. I ALSO had to use a soldering iron to melt it another to break It off. Luckily that’s just key stock so it’s like 50 cents to replace. I also ended up accidentally snapping one side of the head lever. I ended up gluing it and using a soldering iron to melt the crack. These things are a pain in the ass when it’s not a simple 8 tooth gear replacement. I’ll end up making a head lever 3D print too at some point but for now it’s fine. At some point I’ll probably fully swap the upper mech. Anyways
Rant over. Thanks for watching.