Grab N Drive

Рет қаралды 252,216

9 жыл бұрын

The Grab N Drive is the latest concept in post driving. Designed by Exac-One and manufactured in the UK, this modular system allows an excavator operator to handle, place and drive posts without the assistance of a banksman. If required, the grab unit can be removed in minutes and a top-mounting bracket fitted to the breaker to enable its use in a traditional manner.
Optionally the unit can be supplied with a tilting device or a hydraulic diverter kit, which would enable the grab and hammer functions to be operated from one double acting circuit.

Пікірлер: 28

@KarasCyborg 4 жыл бұрын

None of these post pounders ever show it working in hard pan caliche/rockey soil. It's always a moist pasture.

@ringerson4x4 6 жыл бұрын

I think a tray of some kind hanging from the blade would carry extra posts conveniently, and I would have the excavator 90 degrees from this position so I could sight down my previous posts to line them up.

@engchoontan8483 Жыл бұрын

Selling point, hydraulic seals same lifespan.

@grantpiper6241 6 жыл бұрын

Why not use the chain as a plumb line to judge the straightness and also the depth gauge.

@jamesbackhouse653 9 жыл бұрын

Not sure what that would be like in stoney ground 😕

@stephenhansen8906 7 жыл бұрын

ye I would say it needs a trailer or the post needs to be set out first on top of having to drop the rest of the load off before you get started it's only a few post at a time so you would have to refill if you could pull around trailer or something this would be ok

@jmm4081 3 жыл бұрын

How do you insure it is plumb?

@patrickmadden1705 8 жыл бұрын

great bit of kit.

@grantpiper6241 7 жыл бұрын

or loaded from a magazine on the back of the digger

@jasonjones9291 7 жыл бұрын

Thats nice but rates we get in Georgia we do good to buy a new set of hole diggers.

@ajs96350 3 жыл бұрын

Would be nice if it was a little bit more realistic, those posts are going 12" in, max.

@oldpete3153 6 жыл бұрын

Great looking set up, but after watching this demo I can see so many ways to improve the process including a more skilled operator. Prime example of operator inexperience is working over the side of the undercarriage on a lift, machine airborne dancing around, hard on the machine as well as the operator. Lift with the blade to the front and lowered to take the load and crowd close to your lift. Nice set up though, much more improved over my gear.