Depending on your settings you may see Center instead of High and Low at the 6 minute mark, in that very same effects window click on the "Val. Readout" button at the bottom right (of just the effects window!) until it says "High/Low" on the bottom line.

Thanks for creating this video, I feel as there is closure in the sense that the viewer has just enough to go on and created some good looking shows.

Nice to see you´re continuing your video tutorial :D

This was just what I needed. Thanks for the help.

first thing I learned in this video: you can move the command overlay!

Love Your Tutorials!

thanks Alex, nice video

El.mejor video mejor explicado que eh visto gracias

I love using position presets as "borders" for an effect. Much better than dealing with percentages and numbers.... I have one question (not effect related necessarily) -- If I wanted a position movement to go from Cue 1 to Cue 2, and taper the speed down as it ends along the fade time, how would I go about that? (i don't want to work with speed controller, but built into the cue stack....)

Hey Alex

I have a question, how to fade a fixture independently in a cue ? thanks !!!

Can I use my color palette that references all my fixtures as the reference in a color step effect and it will still be a selective effect? Or will that make the effect global so I have to recreate the color palette?

Hey Alex, how can I put a prism effect on a few of my Platinum HFX spots? im using grandMA2 on pc. Thanks! love your videos - Matt

Is it possible to get the show file for this session?

How do I make effects or even just cues where the dimming of a group of lights are offset from each other? Not sure if you know what I mean..I know how to do in other consoles but not sure how to do it in MA.