A few weeks working up north by the coast in January stripping 35mm h07 in a glorified tent, that was awful too

Heat shrink over the ends of the cables in charger would be a neater termination.

Top tip! Always use the Green/ green & white pair: Solid Green + Green & white - Should be easy to remember with “Green” Hawk

Very nice install lads. Too bad about the big grey PV box, but it wasn't your fault. Looks might stupid.

Hello lads not too cosy i hope get off he said i am like you i hate working in the cold i remember glanding off armoureds at Ciba Giegy factory in Cambridge one winter and i hated it i was constantly nipping into the canteen to grab a hot drink to defrost and get back to work i think sparks should get a cold weather suplliment it just numbs the brain and you cant think straight. oh what wonderfull memories not well done for sticking with it.

Nice install Mike,your work is always top quality.

Enjoyed the video. Lu looked freezing. Get him a HiViz Parker jacket or something. The weep vent above the Zappi looks iffy, as do some of the others. Keep up the good work.

Nice video Mike looks like you needed a wind breaker down there

If I was the client, I’d ask if you can fit another BG board replacing that PV monstrosity, two small black boxes are much nicer than that huge grey thing

Invest in a good heat gun, use it to warm up the sheathing of the cable making it easier to work with.

The new ev fuse box should have been placed below the meter box . Would have looked neater.

Why did you not fit the tails back entry?

Hi I am not an electrician, I would like to ask is there a reason why the live feed does not run from the consumer unit to the wall charger, thanks

Her one for you how do you know if your on the end of a looped supply?

Hi, is it cheaper to add the BG conser unit as you have in the video that to wire back from the internal consumer unit and have to use trunking and 5m of extra cable?? I mean, was the job classed S standard installation or was the BG unit an extra?

Where’s the Carhartt/Klein beanie from?! Mike from Residual Current has one too but I’ve idea where you boys are getting them.

nice install, been looking at the outdoor ccu's from BG. 16mm tails on 100A fuse? If this is acceptable i'd be happy to do this myself I always use 25mm but they are a right pain sometimes!

DNO sponsor you to do that?😂😂😂

My mains is shared, it has 2 black cables come into the house it terminates in the DNO fused head then is wired into a 2 gang isolator before going into the meter. Who would be responsible in getting the DNO to change it to a "none shared" supply? I've put of getting an electric vehicle because of the shared supply & prefer a petrol / Diesel as its easier to fuel up & I do between 50 & 150 miles daily. Therefore don't trust the range of electric vehicles so far, OK they might improve in the future. I'm just curious of who would be responsible in contacting the DNO, the electrician who fits the charge point or the garage supplying the car?

You shouldn't even be fitting henly blocks in the meter box

Plinth Course? Damp proof course.

No NICEIC no napit required in another countries only in the UK

Typical solar monkeys making it look a mess with an ugly box and cables scragging about.

Working in Norway no need to have Permission from DNO No JIB No ECS No CSCS No Black card yellow card No UKAS register no United Union registered No Ring circuit only in the UK i see all those 15,000£ to have all those things to work