Grid Independence Test in Ansys Fluent | Mesh Quality Inspection

No video

Grid Independence Test in Ansys Fluent | Mesh Quality Inspection | Grid Independence Study |

Рет қаралды 14,768

Dr. VENKY'S -Easy Learning Knowledge is Strength

Күн бұрын

For Easy Learning
subscribe here: bit.ly/Subscri...
In this video procedure for conducting the grid independence study in ansys fluent is provided with detailed simulation example. Convergent nozzle is considered for the simulation.
#GridIndependence #AnsysFluent #gridtest #meshvalidation
Grid Independence Test in Ansys Fluent | Mesh Quality Inspection | Grid Independence Study |
Grid independence study, Ansys fluent,Grid independence test,Mesh validation,mesh quality inspection,CFD,Convergent nozzle,Velocity,fluid flow, multi phase flow,flow through nozzle,velocity contours of nozzle ,tetrahedron mesh,meshing procedure,accurate results in CFD, water , incompressible flow, incompressible flow through nozzle,pressure drop,pressure drop in nozzle ,incompressible flow in convergent nozzle, ansys tutorial for beginners, ansys fluent,convergence

Пікірлер: 11

@dr.venkys-easylearningknow915 4 жыл бұрын

For Easy Learning subscribe here: bit.ly/SubscribeDrVenkysEasyLearning

@Rationalmale1608 3 жыл бұрын

Good Information sir

@user-mw6ej1lc7o Жыл бұрын

Thank you

@user-mw6ej1lc7o Жыл бұрын

Can you please make a video of the Grid Convergence Method?

@dr.venkys-easylearningknow915 Жыл бұрын

Sure

@mounarahal256 3 жыл бұрын

for independency test, should i have the same type of meshing (hexa, tetra,..) in the different parts or i can do it if i have two different meshingd at the same time(hexa+tetra).

@dr.venkys-easylearningknow915 3 жыл бұрын

You can use both hexa and tetra. But the output result should be same for coarse, medium and fine cells. This is the condition. Also refinement ratio should be greater than 1.3.

@mounarahal256 3 жыл бұрын

@@dr.venkys-easylearningknow915 thanks but i don't understand the output result? what is it? and also to understand be precisely, for example if i have a rectangular plate (part1) meshed with tetra cells and it is circulated with a tube (part2) which is mesh with hexa mesh, should i dp the independency test at the same time for the two parts or i do them independently? and for the refinement ratio you mean at each part with different mesh i should have 1.3?

@ifti5 3 жыл бұрын

Sir if velocity value for coarse,medium and fine is different then which mesh to be chosen

@dr.venkys-easylearningknow915 3 жыл бұрын

Always select fine mesh

@jillebit8105 2 жыл бұрын

But in this scenario you can't be sure that your finest mesh was fine enough, because further refinement could still have an impact. So, I guess you should test with further refined meshes and check if the output results indeed are not dependent on the mesh.