Grizzly 700 | Code 12 | What I Found Was Wrong

No video

Grizzly 700 | Code 12 | What I Found Was Wrong

Рет қаралды 6,103

Grizzly Greg

Күн бұрын

Пікірлер: 27

@JimikeRandolph Ай бұрын

Nice video... good information for the solution to my problem....quick easy to the point ...no bs saved me time .... And money....and headache.....thank you sir 🎉

@grizzlygreg8922 Ай бұрын

Glad it helped you out!! Ride On!

@Van1018s 6 ай бұрын

Been dealing with this on 2015 griz700 and a 2014 griz550 for about 4 years. I bought them at the same time. They were basically driven in all of the exact same places as me and my wife went everywhere together on them. And they started doing it at the exact same time. Around 3000 miles of pretty easy riding. No mud or water. I cannot figure out the problem. I have tried everything that you are suggesting and it does nothing but if I just simply sit there and tap the start button over and over and over sometimes it starts on the first try sometimes it takes 200 tries but they always start. Good video by the way. Very thorough.

@grizzlygreg8922 6 ай бұрын

Thank you for the feedback. I tell you what, when that code 12 came up and started reading up on it I got pretty nervous because of all the different reasons the forms said.. glad I eventually figured it out.. there was a couple of frustrating nights involved though

@JesseBeamon1022 4 ай бұрын

I’ve got a o8 crank with no spark. Spins over perfectly just no spark at all. New coil spark plug. Any advice. Oh and the dash just has the e on it.

@grizzlygreg8922 4 ай бұрын

Damn, not sure where to start there.. I think I would start by making sure battery is good and then move down the line

@darrylgurbach7366 17 күн бұрын

Did you get it figured out? My 08 just started this. Started it up and was warming it up for a few minutes and went to move and it died. Started again then died again and won't start now. Cranks over just fine but I do have a code 12 showing up now so now I'm wondering if my crank position sensor is actually the culprit

@LoneStarTexas897 2 ай бұрын

Question. Will a fault code stop it from starting. And what is a code 14 on Yamaha atvs?

@grizzlygreg8922 2 ай бұрын

Code 14 is an intake pressure sensor error. And yes certain fault codes will stop it from starting.

@780Aleks-AB Жыл бұрын

I had a code 12 on my Grizz too. Found out a clip was broken on my rectifier so the plug came loose. Couple zipties and problem solved haha. But sometimes you throw money at it till its fixed kind of deal. It happens.

@grizzlygreg8922 Жыл бұрын

Yea I read fourms for probably a hour and everyone had a different issue it seemed lmao.. I was like ooooo shit

@ChesterOkay 2 ай бұрын

I bought a new starter A new sator And new solenoid switch