HAAS UMC 5 axis CNC MILL SETUP AND CALIBRATION

Рет қаралды 8,245

Жыл бұрын

Hi Folks,
This week I show you some of the setup and calibration work that I did on the Haas UMC 750 ss 5 axis mill. I learned a good amount and I have more to learn. Enjoy!
The spindle fan clip is from the Haas Website BTW.

Пікірлер: 16

@photonseriescom Жыл бұрын

Thanks for sharing, very informative 👍

@DragonflyEngineering Жыл бұрын

Thanks for watching!

@nidhinfrancis123 11 ай бұрын

Intresting and veryuseful❤

@hiiarrr Жыл бұрын

It could be that your tool length is off. try milling two opposite faces with the front of the cutter and measure the dimension

@mattstricklett1892 10 ай бұрын

Yeah so one u get the machine leveled at 0 and get its twist leveled out at 90deg u need to set the machines new locations and the only way to do that, if ur not wanting to offset every program or call a tech, is to buy a 500$ haas maintenance key to be able to adjust the settings. If u can’t get it dialed in to .001 or better at 0 and 90 ur machine might need a alignment which is usually done at the factory so that is worst case. Cuz u would need to call a special tech to work on it. But everything else u should be able 2 do. Might need that magnetic level tho.

@DragonflyEngineering 10 ай бұрын

Thanks for the tips. I think we got it tunned in pretty good, ~0.0005"

@Petertje94 5 ай бұрын

It's better to set the ball further from the center of the table. The calibration cycle finds the rotation point of the axis. If the ball is more off center the amount of error is magnified and it's easier for the machine to adjust for that.

@DragonflyEngineering 5 ай бұрын

Thanks for the insight!

@SOLO-ht2cc 6 ай бұрын

Can Haas machine be Jogged without referencing it first after turning it on?

@GregsGarage Жыл бұрын

WAY more involved than a 3 axis!

@DragonflyEngineering Жыл бұрын

Yes, it is! Update: I got the test part to be within 3 tenths! The tool setter was not level and the probe tip extension was a little loose

@GregsGarage Жыл бұрын

@@DragonflyEngineering 3 tenths is pretty tight! There are so many moving parts... I'm having trouble wrapping my head around how they maintain that small of a tolerance stack.