Haldex Service VW Audi (GEN 4 Filter replacement & Torque specs)

Рет қаралды 18,778

Күн бұрын

How to service a Haldex coupling, change the fluid G055175A2, used on most VW and Audi rear differentials. How to identify the Haldex fitted = GEN 4 units have the filter above the haldex pump and Gen 5 omitted this filter.
How to service the differential side of the Haldex unit
• Differential Service -...
This is a useful video which shows you both ways of completing a Haldex service on your Audi / VW / Skoda car. The tools required are fairly basic from a nose plier, flat screw driver, Groove Joint Plier also called monkey pliers. Ratchet set with different sockets, Hex Bit Socket Set or allen keys, a torque wrench, oil pan, oil pump or syringe. The parts can be seen in the video, main thing is the Haldex service kit.
It is critical that the vehicle is level during the whole process, especially when filling in the new fluid either using ramps, jack stands, a jack or even a hoist which would be ideal. Vaico, Febi, Liquid Moly, genuine VW, Borg Warner all make the haldex oil / fluid. Borg Warner is the creator of the Haldex system. The process is almost similar to a standard differential service with the key difference being the temperature of the fluid which has to be between 20°C to 40°C (68F = 104F). As seen in the video this can be monitored with VCDS (Vag com) or a probe type thermometer.
Service schedule is 60,000kms under normal driving conditions. If the vehicle is used in harsh environments, towing or race conditions this will bring the service interval down significantly.
---- Time stamps Haldex Service ----
0:00 - Start of Haldex Service Generation 4
4:09 - Opening fill bolt & filter bolts
6:04 - Turning on the pump using VCDS
8:32 - Removing Drain & fill bolt
9:32 - Removing filter & cleaning
12:04 - New VS Old Filter
12:52 - Installing new haldex filter
13:43 - Torque specs / settings for bolts
14:07 - How to Fill Haldex fluid
14:45 - Check Haldex Fluid level
15:50 - Tightening / Torque fill bolt
Pump bottle used in the video is similar to one one below:
www.ebay.com.au/itm/302843253804
Disclaimer: This video was created for informational and educational purposes only. I cannot guarantee against the improper use or unauthorised modifications of this information. No liability for property damage or injury incurred as a result of any of the information contained in this video is assumed. Use this information at your own risk. I recommend safe practices when working on vehicles and with tools seen or implied in this video. You are using the information and automotive parts shown in this video solely at your own risk. It is not intended to be a substitute for the professional advice of a service centre or mechanic.

Пікірлер: 19

@najwanr5786 Жыл бұрын

Thanks! Diy went flawlessly. Those without VCDS you can just start your car engine it charges the pump and pushes the filter out as well. Shut the engines after a few seconds.

@AutoBuddynz Жыл бұрын

Great! Thanks for the info

@GOLTURBO555 Жыл бұрын

Terrific! Superb! Thank you very very much, helped a lot, I did my self the oil change. Cheers mate!

@AutoBuddynz Жыл бұрын

Appreciate the comment. Thanks!

@m4cdemos 7 ай бұрын

Thank you for posting this, although I'm not sure what was achieved by running the pump from VCDS before filter removal - in other videos I've seen, the pump runs for a few seconds longer then you see the white filter cover emerge to where its full width can be grabbed by a set of pliers and popped out without all that faffing about.

@AutoBuddynz 6 ай бұрын

Yea you do not need to run VCDS i showed it in the video as some ppl will need to do so if the filter is jammed in place due to lack of servicing etc

@iainchristy5631 27 күн бұрын

Hi I'm getting a wobble like effect or vibration accelerating at 2k -2.2k revs on my manual 13 reg Audi Q5, could this be related to haldex oil being low or bad quality

@townley1017 Жыл бұрын

Hi, on vcds for me the pre charge pump option only comes up sometimes and not others. Should I also expect to see some oil dripping out once it’s precharged?

@AutoBuddynz Жыл бұрын

Generally yes, there should be some oil from the filter as seen in the video.

@ryanscarver Жыл бұрын

I notice you mention torque specs for the Haldex filter. Were you able to get a torque wrench on the top bolt? It doesn't look like there is much clearance. Does the head of a torque wrench contact the surrounding area?

@AutoBuddynz Жыл бұрын

Correct its very tight in that area. I know from experience how tight to go without a torque wrench. The bolt bolt is easy, so use a torque wrench here if you can. The top tighten it tight but not overly tight. Get a feel of 6nm on the bench with a bolt and nut.

@psalminen8673 Жыл бұрын

What did you do with the spring in the filter? noticed you took it out from the new filter?

@AutoBuddynz Жыл бұрын

I took it off the new filter as the original one did not have a spring. As I bought an OE kit which is used for many different models hence why at times certain things are additional.