Learn the steps to lay out and make a slip joint using hand tools. This is one of the nine joints Ron Herman teaches in bit.ly/JoineryChallenge. For everything woodworking visit www.popwood.com
Пікірлер: 10
@ryancheney27616 жыл бұрын
In case anyone is confused, pretty much everywhere else I've ever seen this joint described in a decade of devouring books, DVD's, magazines, internet blogs, KZfaq channels, etc., it was referred to as a "bridle joint." Strange they wouldn't use what is by far the most common name for it, but maybe that's mentioned elsewhere in the video. By the way- If you're wanting to learn how to sharpen hand saws, Ron Herman's video on that is really, really good. Highly recommended.
@jameslucas65896 жыл бұрын
Ryan Cheney Yep, you are right. It’s a bridal joint. Commonly used in window sash making along with sliding dovetail which is a much stronger joint. The best thing about the sliding dovetail is it does not require clamping or pinning.
@mariom80975 жыл бұрын
Good vídeo for learning how to fast adjust a bridal joint when rough cutted. As Ron says a Master is not the person that doesnt make mistakes but knows how to fix Them. Thanks Ron.
@jameslucas65896 жыл бұрын
I’m confused. First the mortise is too short, next the tenon is not long enough. Can a master please ‘splain that to me? 2+2=not enough. Plus what just happened to the overall length of the board? Do you now shorten both sides? I’m not sure I can figure this one out. I’m thinning “cut it twice and it’s still too short”.
@wb_finewoodworking6 жыл бұрын
A very good demonstration on sneaking up on a tight fitting joint.
@lbhunter63415 жыл бұрын
I'm surprised he didn't use a backsaw...
@jcedArtem6 жыл бұрын
He had problems on each step... It's better to name this video "see how not to do". (Facepalm)
@redbank4936 жыл бұрын
Was not impressed with this
@rollingstone30176 жыл бұрын
Sorry, but that's a pretty bad looking bridal joint. Ragged, and with huge gaps. Embarrassing really.
@yardlimit86955 жыл бұрын
amen,,,,,,,,,that is exactly what i thought.........i even said to myself if i made this video i would not publish it............