So I had this idea and it took me a bit longer than expected to create but I'm pleased with how it turned out.
For this video, I used pinecones, epoxy, and copper wire.
The epoxy has been sanded to 10000 grit and finished with polish and a buff.
Let me know what you think, and if you'd buy one!
Axminster tools used in this video:
www.tagserve.com/clickServlet...
www.tagserve.com/clickServlet...
www.tagserve.com/clickServlet...
www.tagserve.com/clickServlet...
www.tagserve.com/clickServlet...
www.tagserve.com/clickServlet...
________________________________________________________________
Social Media:
Instagram: harrysmith_woodturning
TikTok: @harrysmithwoodturning
Second Channel: / harrysmithshorts
Email for quotes and queries: harrysmithwoodturning@gmail.com
__________________________________________________________________________
Starbond:
Use the code: HarrySmith , for 10% OFF Site-Wide - starbond.com/
__________________________________________________________________________
Axminster:
This channel is supported by Axminster. Use this link to support the channel, and buy your own Axminster equipment. www.tagserve.com/clickServlet...
__________________________________________________________________________
This video was edited by / @itmjp08
__________________________________________________________________________
For the custom coins used in the bottom of my pieces head to vonHanke on etsy: www.etsy.com/uk/listing/79628...
__________________________________________________________________________
Disclaimer:
My videos are for entertainment purposes only. Some of my techniques might not be the "best" or safest, so when using any tool or machinery always read and understand safety/manufacturers guidelines first.
And Yes, I'm aware that wearing gloves while woodturning is considered an unsafe practice. The gloves I wear are tight-fitting and don’t have any loose threads. I wear them for the protection of my skin. This is a risk that I am willing to take, however I am still very conscious of the potential danger and I do not touch any spinning parts of the lathe. DO NOT copy my actions if you feel unsafe doing so.