in this video {621} TNY266PN Low Power Offline Switching IC, Test Circuit, Datasheet, SMPS Sample Circuit Diagram, i discussed TNY263, TNY264, TNY265, TNY266, TNY267 & TNY268 Low Power Offline Switching IC, Test Circuit, Datasheet, SMPS Sample Circuit Diagram. it is used in flyback topology to drive low power smps switch mode power supply circuits like mobile chargers, standby power supply circuit in LED, LCD Tv, computer ATX power supplies, and mobile phone chargers and adapters. it works at
#tny266 #tny267 #tny268
this ic family is fully integrated auto-restart for short circuit and open loop fault protection
saves external component costs
Built-in circuitry practically eliminates audible noise with ordinary dip-varnished transformer
Programmable line under-voltage detect feature prevents power on/off glitches
Frequency jittering dramatically reduces EMI (~10 dB)
minimizes EMI filter component costs
132 kHz fix frequency operation reduces transformer size - allows use
of EF12.6 or EE13 cores
Very tight tolerances and negligible temperature variation on key parameters eases design and lowers cost
Lowest component count switcher solution
Expanded scalable device family for low system cost
Lower system cost than RCC, discrete PWM and other integrated/hybrid solutions
it is cost effective replacement for bulky regulated linears
simple ON/OFF control - no loop compensation needed
no bias winding - simpler, lower cost transformer
simple design practically eliminates rework in
TinySwitch-II integrates a 700 V power MOSFET, oscillator, high voltage switched current source, current limit and thermal shutdown circuitry onto a monolithic device. The start-up and operating power are derived directly from the voltage on the DRAIN pin, eliminating the need for a bias winding and associated circuitry. In addition, the
Minimum continuous power in a typical non-ventilated enclosed adapter measured at 50 °C ambient.
Minimum practical continuous power in an open frame design with adequate heat sinking, measured at 50 °C ambient (See Key Applications Considerations).
Packages: P: DIP-8B, G: SMD-8B. For lead-free package options, see Part
Ordering Information.
TinySwitch-II devices incorporate auto-restart, line under voltage
sense, and frequency jittering. An innovative design minimizes audio frequency components in the simple ON/OFF control scheme to practically eliminate audible noise with standard taped/varnished transformer construction. The fully integrated auto-restart circuit safely limits output power during fault conditions such as output short circuit or open loop, reducing component count and secondary feedback circuitry
cost. An optional line sense resistor externally programs a line under-voltage threshold, which eliminates power down glitches caused by the slow discharge of input storage capacitors present in applications such as standby supplies. The operating frequency of 132 kHz is jittered to significantly reduce both the quasi-peak and average EMI, minimizing filtering cost.
You Can also check these videos
ATX POwer Supply Circuit Diagram Explained • {570} ATX Power Supply...
300 Watt Half Bridge Power Supply Repair • {592} 300 Watt SMPS Ci...
How To Repair SMPS • {528} How To Repair SM... 132KHz switching frequency, it uses very few external components. as it have internal oscillator circuit, so there is no need fo any RT/CT and compensation circuits. it uses Enable pin as feedback circuit to provide voltage regulation. and same pin is used to low line voltage at DC rail. its internal current sense circuit is used to provide constant current feature by adding Leading Edge blanking option.