😎😎😎

the one wear purple and red scarf..

We have seen the prototype for Donatello he turns into a helicopter. I'm guessing to be like the old toy if you had it growing up. But yes we need one of the turtles to turn into the blimp. I'm not sure what Raph would turn into. Maybe a tank I guess they would have to look at all the old toys and see what could work.

thx

😎😎

The turtles are trying to get a Direct TV signal. 😂😂

@@doro626 LOL

the peg is extremely tight. So tight that I completely removed the screw and it didnt loosen. The plastic tolerance is all wrong.

@@doro626 so once you remove the screw did it work better? or did you have to do something else to loosen it?

@@roonis418 SO I took the screw completely OFF. To be clear there are TWO screws in that area. I have see the plastic tear off on another video review ( it says I broke it in the title). I removed the black screw that has a built in washer. When i took it off, the tolerance between the foot and the peg is was on was so tight I still couldnt get it to turn . I had to rock the piece back and forth in slow increments until I felt comfortable. Im not sure if lithium grease degrades plastic, otherwise i would have put some of that on it.

9:55 Also at this part. Take note that the yellow plastic is holding onto that grey round piece. So you cant flip the wheels out , unless you pull down slightly to un-notch it. You can see the motion on the left foot better than when he did it on the right. Use a spudger or plastic pry bar. More than a few joins I had to push a part slowly. They use metal ones in a lot of these videos, so it you are comfortable using metal on plastic, use that.

@@doro626 Thanks this was pretty helpful maybe you could do a quick video on which screws and washers you removed so people can see which ones so they wont have any brake issues. I don't have mine in hand yet its on the way but before I mess with it I want to remove or loosen the problem areas.