HiTRAX Traction Motor Armature Rewind Process

HiTRAX Traction Motor Armature Rewind Process - Houghton International

Рет қаралды 122,161

11 жыл бұрын

HiTRAX™ is our traction motor life extension solution.
HiTRAX™ is an insulation system proven to extend the life of DC and AC traction motors for over 12 years. It is a combination of both our traction motor and high voltage expertise applied to solve the problem of deteriorating dielectric capability of problematic motors.
For further information visit www.houghton-international.com...

Пікірлер: 24

@WA1LBK 2 ай бұрын

Impressive process! 😊

@tartin69 11 жыл бұрын

Hi, At 1.00 during the wedging process,there's a small (Dolly) in front of the main wedge,is this smaller to pre fold the insulation ,so the main wedge doesn't damage the slot liner,Mart

@alexandervx863 4 ай бұрын

Very good job

@SahilKhan-vz9gt 3 жыл бұрын

Traction motor 75 volt 100 amp 950 rpm BHEL ki motor hai railway ki is wait 440 kg hai to is motor ma copper kitna nilkaga koi btah skta h bhai .....

@irineuluiz9847 6 жыл бұрын

trabalho muito bem feito parabéns

@ranjitdasdirectorofswadhas9 4 жыл бұрын

very nice work..

@cesartafoya18 5 жыл бұрын

como se llama la máquina que fabrica la solera?

@mustang2440 3 жыл бұрын

How much voltage and current is needed for full power?

@workonitm8 9 жыл бұрын

I've wound a few. Mostly the old Westinghouse 362 and 370 series.

@gajanansonar1385 7 жыл бұрын

veri veri good nolej

@RamonRodriguez-pd8og Жыл бұрын

PERDÓN. POR. EL TIEMPO DE HACER MÍ COMENTARIO PERO ACABÓ DE VER EL VIDEO Y. SI. PUSIERON CUANDO SE SOLDA CON ARGÓN.

@HmongGuitarPlayer 5 жыл бұрын

Been there done that.

@HmongGuitarPlayer 4 жыл бұрын

Randall Slaughter Good times man. If my hands holds up will still be doing it.

@user-xh5qg3rv4x 7 жыл бұрын

This motor repair industry who can give me a company, I am a Chinese, want to go abroad to study and study

@Sham3202 7 жыл бұрын

I am winding a 10000 HP Armature on site in a steel Mill. This one is a Toy armature.

@MaaroufMohammedSK 5 жыл бұрын

Shoukat awan i work for a rail company and i repair traction motors and need some professional informations, if you can contact me on my email pls: muhammed.maarouf12@gmail.com

@servistools6254 4 жыл бұрын

👍

@lorenzobeckmann3736 5 жыл бұрын

I wound these; but if you exchangr based on nameplate data-----use old shaft or CAREFULLY measure new shaft. Also, don't brag how big anyone winds; have you wound tiny- like with #36-40 wire?