Рет қаралды 53,312
Check out my 2nd channel, TT Racing: / @ttracingyt
It’s time for some home based injection molding. I’ve had this machine since 2014, but it has been sitting idle for a while now, due to an error on my part. Previously, I attempted to mold some bespoke silicone washers to seal the machine, and did manage to mill a two part aluminium mold ready for recycled plastic. In this video, I make some further repairs and alterations and finally put through some shredded PLA with frustrating results. Is it worth more modifications and testing? At the moment, I think not.
Please note that this machine is sold to suit 110V mains voltage. In Australia we use 220V, and I’m pretty sure I removed one heater and converted the other. If you also use 220V, you would need to do the same or use a step down converter. It’s also worth noting that this machine was never intended to be used with this type of plastic. If I were to stick to the original Plastisol material, it would likely have been flawless.
0:00 Introduction
0:42 Recap
Part 1: • Home injection molding...
Part 2: • Home injection molding...
2:09 Silicone o-rings (again)
2:50 New PID controller (with autotune!)
My new controller from eBay: www.ebay.com.au/itm/304598395639
3:47 Additional chamber heater
4:13 Hose repair
4:28 The compressor gives up
4:42 Machine modification to use a plunger mechanism
6:54 PLA tests and (poor) results
PLA injection molding guidelines: www.totalenergies-corbion.com...
10:02 Virgin ABS (worse) results
11:10 Hot glue test
CNC Kitchenm hot melt glue filament video: • Can you 3D Print with ...
12:10 Evaluation
Recycled plastic sheets video: • Melting plastic waste ...
Industrial injection molding video: • Technology of Injectio...
Buster Beagle 3D: www.busterbeagle3d.com/
13:25 Conclusion
Buy quality and affordable filament from X3D. Buy 3, get 1 free and a free sample pack with every order: www.x3d.com.au
Get Quality Resins from 3D Printers Online. 5% off storewide for Teaching Tech subscribers [Code: tech5]
3dprintersonline.com.au/
Take a look around and if you like what you see, please subscribe.
Support me on Patreon: / teachingtech