Appreciate that you actually show it off at the end.

By far, it is the simplest, most effective small loader I've seen. Well done, sir!

Very impressed with your design and construction of this loader. Thanks for showing it actually working and what it can do. Very good and informative video.

Your upright supports need gussets on them they are flexing back and forth when you push real hard on them , Nice bucket system , good job Bueno thanks ,,, BigAl California

That works very well. Best you order front end parts for that tractor now. You're going to need them.

Im putting a yanmar in to my 425 frame i think its same rear axel and frame. This looks li,e the best front loader ive seen yet. Will try to copy thanks for the example

Well done,

It beats the heck out of a piece of steel at the end of a fiberglass pole. 👍

Nice job brother I’m trying to do something like this for my project thanks

Very nice! great build and well presented. As someone that has been looking for an original John Deere model 40 FEL I can tell you that there are hard to find and when you do they are very expensive so I am intrigued by your design and may just build one. A couple of questions... did you build your bucket or buy one ready made? did you replace the pressure relief valve in the transmission as is recommended with the model 40?

Great video and project.

Amazing work! Well done!

Awesome project! Thanks for sharing! Is there any way to get the plans so that I could have one made up?

It'd be great if you could provide the dimensions you used making the arms; trying to make something for my Bolens H 14

Awesome just found your channel 😎

It's very interesting, great

Well done

Nice job ✌️

It must say in the instructions on those evolution saws "for use on garage floor only" because thats where i see them used every time.

Did you have to change the forward pressure relief valve on the 445 as recommended in JD’s tech manual?

Great stuff. Do you need to take off the starter motor or alternator when welding?

Nicely done. Thank you for sharing. I see you have enough hydraulic cylinder travel to lift the nose off the ground. That was one of my questions. Were the hydraulic cylinders and lines pre-bled so you didn't have to fight bleeding and filling the hydraulic system? I was going to suggest wheel weights, but it looks like you have quite a bit hanging off the back end.

Te salio Mamalon compa

What are your measurements of all the pieces?

No bushings and grease zerks. Maybe next build.

Buen trabajo, puedes dar las medidas de los tubos?

How many real time hours was this build. And approximately how many KGS lbs steel is used

How did you figure out what size cylinder to use for you tractor resavour

how can I get one for a 425?

Very cool. How did you increase the hydraulic pressure?

Determination

Imagine having access to all those tools and a welder and still doing the Tik Tok tack welding technique 😂

What pump do you use for the hydraulics? And what are the specs of the pistons? Thanks. I was doing research on how building one myself. It’s hard to find the correct stuff.

Do you have drawings for this you can share?

منتج ممتاز اين جده وهل هو للبيع

Nice job building, but you need to protect your tractor and the hydraulic rams from the sparks while your welding. A welding blanket works best. Also, your painting technique needs work. You look like your spraying insect killer😁 Your getting overspray everywhere.