That’s right poor maintenance and not driving it for 3 years cause you don’t want to fix it shame on you

Do you mean steering pump or fuel pump? I guess you mean steering pump. I guess you are referring to the boiling sound from the steering pump when the ATF is very low. Yes, if the fluid spills to a certain level the boiling sound gets louder and louder. You may have to put some ATF to see if the steering is stiff, if it's not then the pump is not bad yet. If you check and see that the rack is spilling some fluid then the rack seals needs to be changed. Sometimes the pipes related to the steering might be bad and leaking so you might need to trace the fluid leakage from any of those pipes and change accordingly.

There is a seal in the master break that when it gets weak it starts to feel that way. I will recommend you change the master break toa new one instead of trying to change the seal. You may not get a good one. Sometimes the inner side of the master tube might be worn out also. The best bet is to change the master break.

I had that issue too. I changed the master break. That stuff under the break fluid cup or tank. Don't try to fix it by changing the rubber stuffs inside. Just change it to a new one. Although I got a new one that latter started leaking beneath the cup so I went to the old one and took the cup from there to replace the new one and until now, am good.

When the A/C is activated, the compressor comes on until the car is cool to the set temperature then it goes to idle mode, meaning that the compressor stops by means of thermostat. When the compressor is active the engine does more work to move the car and compressor at the same time. The extra vibrations could be due to damaged engine sittings. For the RPM, that is due to the stress on the engine. There is more load to drive.

I have asked many technicians this question. Some will tell you that it doesn't give any warnings and some will tell you it makes some cracking sound when you are making a turn. On youTube some will say it makes some clicking sound when you enter a gallop. I have never experienced the ball joint failure. In fact, I am so mindful of it that I always check them whenever some work is being done on the lower arms.

It actually gives a sign, when you turn your wheel it makes a creeking sound and when you enter a gallop it makes a clicking sign, people who say it gives no sign are not honda mechanics. As preventative maintenance anytime you change your oil ask your mech to check it. Also there are Chinese and original ball joint, the Chinese one pull easily but the original one is around 7 to 8k.

​@@Delight.AutoCRAFTThis was very informative thanks for this. Also, what do you think about those mechanics that claim to be able to tack the ball joint to prevent pulling. Do you think it's wise? I'd like to hear your thoughts. Thanks

​@@Wils0n_no, it's not wise. The heat from tacking will dry up the grease in the ball joint. I only advise it if the ball joint hole are now too loose

My car is identical to yours, the problem it had was the gearbox then changed when we started it,its bulge was very strong even when we were driving it ,what to do

@@KrispiKris the gearbox needs programming

I am always mindful of unnecessary vibrations when driving the car and while fixing them I always check the ball join. I have some sort of consciousness towards that stuff.

Absolutely yes!

Of course it is

Yes I would, it's a very balanced car even on top speed and the suspension setup is very good.. it feels more sporty and comfortable at the same time.

Yes! It's a very economical car to drive if well maintained. I say this from experience.

@@techloam Thank you

You asked this question at the right time because it just happened to me right now. We are fixing it. I am already filming it to give a better explanation. Thanks

I had transmission issue where the transmission was kinda jumping when I change to either D or R but I replaced the entire transmission to solve that issue.

I guess you mean 800k Naira. Of course you can depending on the seller, his reasons for selling and the condition of the car. It's very possible.

@@techloam please send me your contact I really need if u have any one that want to sell

@@techloamCan I get ur contact too.. I’m interested

It was going to be a series of videos...

Yes...I am just saying the much I know. I have been learning a lot lately though. This is the first Honda I am driving and I am loving the experience.