Looks like a good product, will buy. Just got the windshield you recommended, like it for sure.

Looks good. I like the micro adjustment, that may give me a little more room for my boot. I tried raising the stock lever when I got boots, but I didn’t like it, it was just a little too high, but this might provide that sweet spot... if nothing else, it looks cool.

I installed zeta on mine CRF and regret it now. It's too good for this bike. Will not bend, break etc transfering whole force of impact into shifter shaft which is same crap as oem lever. I think it's better to go bended oem shifter than broken shifter shaft.

Put the tusk shift lever on mine. Zeta makes good stuff.

I have the Zeta shift lever (original) works fine good quality. Not sure this new one would be that much difference

3:20 as you are talking about the stock position, look at the actual shift point compared to the case, matching the spine location raises it about 1/2 inch or so. The bends in the levers are obviously different. Did you end up having to take it of and rotate lower or did you like it raised anyway? BTW nice pegs, I have the same ones on my CRF250L.

Does the shifter have to be specifically for the 300l or can I use a generic one

i find difficulty removing the lever from the spline. any idea how to do it. thanks.