Love your tip on the m5 twist on the wand. Did to decks today wanded that way with no lines!
@jeffmorgan46657 күн бұрын
As usual great info and awesome job
@TheFreshRinse7 күн бұрын
Great job!!!
@moeron3879Күн бұрын
Very nice brother! Everyone remember to be careful to not strip paint off the the structure when your that close to the handrail :)
@southeastsoftwash40206 күн бұрын
Looks great
@MrNick-14 сағат бұрын
Looks great. Which dilution tip did you use for inside the xjet barb? Or was it wide open? Thank you
@perry67711 сағат бұрын
Thanks
@xxillusiionz8675 күн бұрын
Beautiful
@samuelcruz-xy7fx5 күн бұрын
Did you just do straight chem with no water out the bucket? Or did u dilute it with water?
@Fromgreentoclean6 күн бұрын
Have to say it dose work better than SH
@wallacewimmer51916 күн бұрын
😊
@riversidepressurewashing20244 күн бұрын
whats the minimun price to charge for something like that
@susansk8sorrell1233 күн бұрын
Great job...but do I see some stop and start marks? Or is that just going to happen?🤷
@strongarmwash3 күн бұрын
Easy to avoid, I just didn’t care on this one because we are staining this deck and a solid stain
@break-through23 сағат бұрын
What percentage of the chemical you're using ends up coming out of the xjet?
@strongarmwash23 сағат бұрын
4
@Chris724016 күн бұрын
Man i get the same results with 0 lines using the m5 twist. Less pressure than the xjet. Only reason i say this is i saw some lines at 5:31
@strongarmwash6 күн бұрын
Easy to do without doing so. Only reason I wasn’t as careful is because we are staining these decks in solid stain.
@Chris724016 күн бұрын
@@strongarmwash in that case roll on 💪💪
@LucasPerrego-nt7eg5 күн бұрын
Tried this stuff twice and I can’t seem to get results like this. It darkens the wood I’ve used it on, what could I be doing wrong?
@strongarmwash5 күн бұрын
To weak of a mix
@williamwelch15135 күн бұрын
If the wood darkens, which happens a lot, hit it with oxalic acid afterward to brighten it back up.
@susansk8sorrell1233 күн бұрын
Might be a stained or sealed deck he said don't use it on these types.
@upallllnight7 күн бұрын
Oxalic after?
@faceplant7552 күн бұрын
he was prepping for a stain so you dont really need it, oxalic acid is a cosmetic thing and when they stain it the brightened wood would be covered up anyway
@bjbruce96432 күн бұрын
Oxallic also technically balances Ph of wood after SH, allowing wood to receive the stain better. So the question still applies I would say.
@samuelcruz-xy7fx5 күн бұрын
Did you just do straight chem with not water out the bucket? Or did u dilute it with water?
@brianwester53854 күн бұрын
The x jet pulls straight chem from the bucket and mixes it with water in the nozzle. No need to dilute just put the nozzle for the ratio you want