Shipping Label Was Only To Feed The Tissue Paper Through Printer

@@DezignsByChey got it!!

I’m wondering the same

Cricut design space was used for this project.

Both

Inkjet is better for print and cut projects.

Did you figure it out? I noticed that happened cause it was on too long

@@elizavaldez9428 I didn't. Lol. It could have been too long. I just used waterslide and it worked so much better.🙂 thank you for responding.

Any White Tissue Paper Will Do

DezignsBy Chey thanks much gonna try this out

You can also use waterslide paper.

Shaun Shyne what’s that?

It's almost like tattoo paper. You put it in the water and then onto your item that you want it on. www.amazon.com/dp/B076VHHDS3/ref=cm_sw_r_cp_apa_i_EeOtFbV6YWSZ1

Once you've printed on it, you have to make sure to spray it with clear acrylic paint before putting it into water or the ink will come right off. So spray it with the, I use Krylon Acrylic paint 2-3 times, waiting 10-20 min in between sprays. And to make it even more durable, use some Performix Plasti-Dip(clear) spraying the same way as before. Once it's dry, you can put the paper in the water for about 20-30 seconds and then place onto your item (candle, cup, mug, etc) squeegee the water away and then you're set.

I figured it out but thank you for your help.