How to adjust an unloader valve for a pressure washer

Рет қаралды 41,327

3 жыл бұрын

This is how to adjust an unloader valve on a pressure washer. This particular pressure washer is 3000 PSI at 5 GPM.
Also I was too lazy to edit the video when I said "carburetor" instead of "exhaust chamber". So enjoy the blooper 🤣
Here is a link to the pressure gauge
washmart.com/products/pressur...
Here is a link to the VRT3 Unloader Valve
washmart.com/products/vrt-3-b...
These products are carried at Washmart.com

Пікірлер: 18

@tampabaysoftwashpressurecl2339 Жыл бұрын

Thanks for the info!

@lanceduff 3 жыл бұрын

Great video Marco!

@washmart8616 3 жыл бұрын

Thanks Lance!

@santiagogomez186 Жыл бұрын

Great vid. Should make an updated one adjusting an 8gpm unloader

@washmart8616 Жыл бұрын

This is exactly how you do it for an 8 gpm. This unloader is what we install on 8 gpm power washers. Only difference is you'd use either an 8 or 9 orifice nozzle.

@galagauthier 3 жыл бұрын

I Have heard that before but did not understand it ... I think I understand it now...

@JM-yx1lm Жыл бұрын

I don't think I learned jack out of this video.

@kylerice9714 Жыл бұрын

😂 I'm building a new setup and needed a refresher. I don't know if this is allowed but... kzfaq.info/get/bejne/mch7l8WIxqeXoH0.html

@vcash1112 5 ай бұрын

Me too!

@joebag1127 2 жыл бұрын

I have a question maybe you can answer replaced my pump everything works good once I pull the trigger and then release I can never pull the trigger again if that makes sense can you help

@aldavis1609 Жыл бұрын

I have a Honda 3000 psi GCV160. Motor runs great, has plenty of pressure, however when I release the trigger it will not go to bypass mode, builds pressure until it kills the motor...I have replaced the unloader valve. Any ideas what it going on? By the way the washer is only 2 years old. Thank you

@Front9Restoration 3 жыл бұрын

Great video.. and nice shirt!

@washmart8616 3 жыл бұрын

Thanks for giving me the shirt Craig Harrison, the F9 creator!

@gpoh1007 2 жыл бұрын

Where can I get that shirt?

@roccomartino8409 3 жыл бұрын

Perhaps mention what size tip you are using when setting unloader

@washmart8616 3 жыл бұрын

I'm going over the principal of adjusting the unloader. In this case it's with a 3000 at 5 gpm power washer so we are using an 06 orifice tip on this video. If it's a 4000 at 4 gpm we recommend using an 04 orifice tip. When testing a 4000 at 8 gpm we recommend using an 08 orifice tip. There is a general pump chart that has this information that tells you what tip you should be using.