How To Adjust Perkins Generator AVR

Рет қаралды 3,315

7 ай бұрын

AVR is a voltage regulator for generator.
Contact me for the blog post & article writing 👉 sheychicagosolution@gmail.com
During the setting, you need to do adjustment to fix any problem. Ensure there is no wiring or connection issues. If there is, then carry out testing and repair any irregularities.
How to do that is explained below. You can consult diagram during the power or electricity need to be adjust. But you should know that AVR is automatic.

Пікірлер: 9

@daberechiwisdomrolland6716 5 ай бұрын

More Grace my follow engineer ❤️🛠✅

@user-bv1yb8oq3l 7 ай бұрын

thanx a lot of. please make more video about philler and basler and man-B&W AVRs 🙏🏻 adjustment

@mrengine 7 ай бұрын

Noted

@jimmybrad156 5 ай бұрын

'tightening' is clock-wise

@ScottPugev 2 ай бұрын

Hi i got a similar AVR with the one u show but there are no label as to which cable to connect to. Can u tell me which terminal or pin is positive and negative...the othe two cables comes from or connected to T7 and T8. This AVR is to be installed into a 12 leads 3 phase generator. Pls help me out Thanks Sp

@mrengine 2 ай бұрын

Connect the two from the Exciter to a side, then skip the center pin, then connect the other two from the field coil to the other two. Forget the positive and negative.

@ScottPugev 2 ай бұрын

Im still a bit confused...placing the AVR infront of you, the two terminals on the left are connected to T7 and T8 in the termination box, the last two terminals on the right (believed to be positive and negative respectively) connected to the exciter coil (middle terminal n/c)...my question is, do i have to connect them according to their polarity or not? eg. how if i connect cable from T7 to pin 1, cable from T8 to pin 2, the other two cables coming from coil to pin 4 and pin 5 regardless of positive or negative. What i mean is, it doesn't matter which pin to connect to as long as the cables are connected..hope you got the message...thanks a lot for your response

@mrengine 2 ай бұрын

The two from the coil should go to one side , forget about positive or negative. If it doesn't come up, then exchange the two to the other side and the other two to another side.

@ScottPugev 2 ай бұрын

@@mrengine ok i will try. why iam asking just bcos in a smaller generator with carbon brass it is important to connect the cables to their proper polarity and that is positive and negative..in this case, it doesn't matter as you pointed out. Anyway thanks