The spring mechanism on the control handle has changed. No adjustment. Leave the plate loose until you get the pivot bolt in.

THANK YOU VERY MUCH. The manual is useless. Mine is working.

Here's also a tip there are 8 M8 lag bolts. They look similar in length but line them up you'll see that 4 of them are slightly longer than the other 4. The longer 4 bolts are used to assemble the stand base, it gives the little bit of extra length to get a nut on the end. The other one are too short to go all the way through. The instructions are junk but to be truthful after figuring out what bolt went where and be sure to use a bit of gasket maker to help line up the gasket this is actually fairly easy to assemble.

Clear instructions and a nice video - thanks, but man, thats a lot of work to assemble one of these mixers.

Very helpful

Love you man! Thanks

good vid. thank you.

Thanks for this video.. looks like fun. I noticed you didn't line up the Vertical Drum Arrows when assembling the two halves.. wouldn't that make the deep-inside bolt hole line up to a bolt already installed / secured, and not to the open holes?

How much it cost to ship in Bayawan city Philippines

I had assembled mine backwards. The motor and pulley wheel is on the wrong side. Any idea how I can remove the pulley wheel ? I tried it last night but could not get it to release.

Mine motor cover where you hook up the wires only has one ground screw. I’ve assembled and it does not turn on. Help me please lol

Why did they get rid of the spring tightener bolt for the handle?? That was one of the hardest things to assemble. Stupid! At least they put the motor and outside assembly together for you at the factory now

Lmfao, I just built one of these getting paid $25.00 a hour took 2 and a half hours. Because all the bolts was scattered all over the inside of the box when it was opened.!! Someone at the factory was havng a shitty day or something!!

trying to assemble mine today and yesterday. its annoying they give you so little information on the hardware parts. trying to figure out the difference between an M8x60 and an M8 x80 or whatever is Not my strong suite... its coming together slowly, but ugh so frustrating they dont label the Hardware better! gah!.... anyways. it should be intuitive, but its worse than Lego, and i loved those damned things haha... but yeah, better parts labeling and more detailed assembly instructions Would be necessary for them to include for slightly clueless assemblers... lol at least mine came with the electrical and motor hooked up and ready to bolt in. that would be a nightmare for a non electrical assembler like myself... one nice thing i have found at least eh lol... though having to fix some shipping damage. hammer the drum a little bit... easy enough, im good at details like that at least haha.

The hardware isBS in this

Thanks for the video, the instructions that came with the mixer was crap

made me waste 1 hour lol You forgot to tell us about the arrows to line the tubs gezzz all my screws but its ok now had be replaced plus did not tell what screws to use and that made big mess in the end and forgot to tell 3rd bolts in legs ,, thats is good but missing to much info

Not very detailed and didn’t help at all. You didn’t try very hard to make a good quality video. I guess I’ll just have to keep looking for a better video

I had assembled mine backwards. The motor and pulley wheel is on the wrong side. Any idea how I can remove the pulley wheel ? I tried it last night but could not get it to release.