No video
How to bleed a older Yamaha oil injection system.
Рет қаралды 5,953
Күн бұрынOver summer I replaced all my oil injection lines. This video show how to breed a older Yamaha oil injection system with a drill.
@twinturbo3470 2 жыл бұрын
what if you pre fill the lines with oil and then use the drill to full prime the pump. Thats what i was told to do with my Ski Doo 600 SDI. worked like a charm and less run time without oil
@snowmobilemodsfixes3264 2 жыл бұрын
Good idea less drilling
@stevendorey280 Жыл бұрын
Was thinking that watching the video!
@jenellins5476 Жыл бұрын
Thank you this was very helpful
@Jigsaw_knows 2 жыл бұрын
Ingenious 👍
@guskelman3058 2 жыл бұрын
What did you do for the cable setting of the carburetor linkage? Like how far did you thread the cable end in/out?
@snowmobilemodsfixes3264 2 жыл бұрын
I had the carbs off so I just manually pulled the cable wide open.
@guskelman3058 2 жыл бұрын
@@snowmobilemodsfixes3264 I meant for the oil pump cable end that goes up to the carbs. Sorry. Just wondering how far in/out you have the oil pump cable threaded
@snowmobilemodsfixes3264 2 жыл бұрын
@@guskelman3058 when I have it all together. I have it threaded almost all the way up. Depends on cable stretch. Take your throttle leaver and press it down and it should evenly pull the oil cable as you throttle up. Adjust up or down as needed.
Kevin Bergeron
Рет қаралды 6 М.
How 2 Wrench
Рет қаралды 100 М.
trythistv
Рет қаралды 59 М.
Outboard Exchange
Рет қаралды 17 М.