Thanks 2018 NISSAN TITAN. I ended up removing the five screws that hold the glove box in to put the pivot pins back in. The whole glove box pulls out. Removing the screws and pulling the whole glove box out is a much easier way to change the filter.

So, my suggestion is to leave the pins in place, look at the three screws that run at the very top of the glove box door and the two the run across the bottom. take those Five screws out and the entire assembly comes out. Its far easier than trying to get to those three pins especially the center one. Try it and hit me back

Easier way to do this is to remove the 5 screws that hold the glove box assy to the dash. You do not have to fight the pins, nor the retainer cable. Just did mine in less than 5 minutes.

Guys the best way is to removed only the left and middle pin, leave the last one on the right in, it will come out easy .

Hey 4K guy, this doesn't apply to the Platinum Reserve addition. There's five screws, three across the top and two at the very bottom of the trim. The entire glove box will drop out. From there it's all the same. This was on my 2020 Titan Reserve. Thanks for your help

My 2019 gas engine was a pain for a while. The filter has to be compressed to get it in.

The arrows on the air filter, are they pointing up or down?

I see yours is arrow up, my 2018 pro4x goes in arrow down.

Third one is impossible to get to

Easiest method. Messing with the trunk pins is a pain.

5 screws and the whole glove box comes out and it takes 5 minutes.

I’ve never changed mine on my 17 Titan.