You push back the pistons before cleaning then. It would damage the seal of the caliper wtih all the dirt. Bad job here...
@azizkaria4142 жыл бұрын
never use a screw driver to open the gap. Use brake pad separator tools to open the gap. You need to clean the piston first before you push backwards.
@st1100boy8 жыл бұрын
Looks simple. I'll throw some new pads on my Super Duke before my next track day. No excuse not to when it's that easy.
@Ducati_Dude7 жыл бұрын
What does the suspension have 2 do with replacing brake pads?
@SperperoneАй бұрын
You did a couple of things the wrong way: /1 clean the caliper pistons before pushing them back 2/ never use a screw driver to push caliper pistons back 3/ never let the brake calipers to hang on the brake lines itself
@christiang34963 жыл бұрын
WOW! Compressed air and brake dust! Hmmmmmm
@paulfletcher82664 жыл бұрын
What was the torque setting?
@1973hamr3 жыл бұрын
Terrible job in so many ways...OMG
@K-Mac_Racing_557 жыл бұрын
I would not let this guy/shop work on my bike, period.
@tisanaij73367 жыл бұрын
Kevin McDonald Why?
@TexasMonster7 жыл бұрын
Tisanai J i assume his comment comes from the fact that you pushed the dirty piston back into the caliper using the pads with a screwdriver. all the dirt on the piston went inside the caliper and that often causes the seals to fail.
@Ducati_Dude7 жыл бұрын
unleaded2k --> I was thinking the same... ✔
@KTMSAS-Duc1200S7 жыл бұрын
Ducati Dude plus he spayed the brake cleaner all over the wheel and tire. Just too many incorrect methods for me....I guess I just baby my bike way more than average lol
@dzk334 жыл бұрын
Also, he left the calipers to hand by the hose.
@gaetanostica45749 жыл бұрын
bravo.
@tisanaij73369 жыл бұрын
grazia
@syumassh7 жыл бұрын
Whats the torque settings on the caliper mount?
@neilleigh18977 жыл бұрын
39nm for a gsxr, just t check to be sure but that is probably covers most radial mounts
@falcn125 жыл бұрын
Did he use the torque wrench to undo the bolts?!
@alambakar36146 жыл бұрын
How many torque the mechanic used. It clicks 4 times,if 15Nm,it means 60Nm. Too much. The tread at the Ohlin fork will damage.. better,dont go to this workshop...