How To Change The Oil And Filter On An ATV Bombardier Quest 650. Also there are 4 grease points on each arm on the front end that should be greased at the same time.
Пікірлер: 37
@johngibson84803 жыл бұрын
Thanks for this video...your machine looks very very good for its age. I bought a Quest a few years ago and mainly left it in the barn BUT today I started to look at it and will do some small work such as fluid changes etc.. Your video(s) will certainly help me out on this "quest". Thanks!
@PovertyPointCustoms3 жыл бұрын
Thank you, hopefully there will be some snow plowing videos soon!
@jesusromero54762 ай бұрын
Thank you. This really helps
@PovertyPointCustoms2 ай бұрын
Thanks!
@rothesayprepper3 жыл бұрын
Always good to check your belt when doing oil changes, nothing worst then blowing a belt in the middle of the woods.
@PovertyPointCustoms3 жыл бұрын
Totally agree, when I swap it out I'll keep the old one as a spare
@jerryjacobsen98902 жыл бұрын
Great Video . Thank you.
@PovertyPointCustoms2 жыл бұрын
Thanks
@MadSpooky Жыл бұрын
I appreciate your videos. I have a 650 that the speedo doesn't work - it lights up, the odometer works, but the speedo never moves. Have you run into that?
@kevinparrott2622 жыл бұрын
These videos have helped me out a lot on my quest. Have you needed to replace any u joints? I need to do my front ones and not sure how to go about it. Thanks for the videos!
@PovertyPointCustoms2 жыл бұрын
Thanks, haven't had to replace them yet
@jessedonaldson5328 Жыл бұрын
Hey dude, i have a question for you, the little screw right under the screw for oil filter, i unscrewed it and red liquid came out. Whatis it and how do i refil it? Thank you
@kellyg9892 жыл бұрын
I have an issue with a john deere 650 its a bombardier 650 quest with John deere stickers slapped all over it. It runs good for about 20 minutes and then starts backfiring and acting like it's not getting fuel. I've watched all of your videos and alot of them have helped me get this thing going. Drive belt, idle set, oil change etc. I wonder if I have to replace gasket between carb and motor like you did in one of your videos any ideas would be helpful thanks
@PovertyPointCustoms2 жыл бұрын
Mine was doing the exact same, replacing the intake boot between the carb and engine fixed it, I also found a small tear in the boot from the carb to the airbox also I had to fix.
@mainemoose7443 Жыл бұрын
Hey!! I just picked up the same machine from someone who had the starter cover off the starter solenoid not wired and was like parts for this machine are easy to find..bunch of BS. Anyways, I have the service manual and I cant see how to hook up the starter solenoid to the correct wires along with where the external coil wires to. Could you send me some pics of yours for a reference please! Ive been trying ofr months now to get this quest going but no luck..THanks!!
@PovertyPointCustoms Жыл бұрын
I'll take a look this week and see what I can find
@mainemoose7443 Жыл бұрын
@@PovertyPointCustoms AWESOME THANK YOU SOOOOOOO MUCH!!!
@mainemoose7443 Жыл бұрын
@@PovertyPointCustoms Just wondering if you had a chance to look at the starter solenoid and see where all the wires go including the external coil. :)
@mainemoose7443 Жыл бұрын
@@PovertyPointCustoms Any luck taking a look to help me out with my electrical hookup issue?
@johngibson84803 жыл бұрын
What size TORX wrench do you need to remove the oil filter cover? Sadly, I will need to get this...always something else to buy....I also think it would be a good idea to get an new O ring...would you know this size too? Thanks
@PovertyPointCustoms3 жыл бұрын
I was able to get it unscrewed using an 8mm socket (just be carefully not to strip it), mine wasent on super tight so it unscrewed easily. I'm not sure of the o ring size but I'll see if I can track it down and get back to you
@slavsquad3 жыл бұрын
Does the engine oil go Tot he transmission as well or does transmission have a separate drain and fill spot?
@PovertyPointCustoms3 жыл бұрын
The same oil lubricates both engine and transmission
@slavsquad3 жыл бұрын
@@PovertyPointCustoms thank you
@maritimegoalie3 жыл бұрын
Can I suggest using rubber gloves....if you don't have a latex allergy?
@PovertyPointCustoms3 жыл бұрын
Safety is key, thank you for looking out for me :)
@mfacote Жыл бұрын
Hello, where can 1 get one of those filter. I'm from Montreal Canada. Thank you. And where is de spark plug
@PovertyPointCustoms Жыл бұрын
The spark plug is on the top of the motor when you pop the seat off. The last filter is used I got of Amazon if you search:Brand: AHL 4.4 out of 5 stars4Reviews AHL Motorcycle Oil Filter for BOMBARDIER QUEST 650 MAX 650 2004 / QUEST 500 495 2003 2004 / QUEST 650 644 2002-2004 / QUEST 650 XT 650 2002 2003 (PACK OF 2)
@mfacote Жыл бұрын
@@PovertyPointCustoms My VTT is a 2006.
@mfacote Жыл бұрын
@@PovertyPointCustoms Hoypeyfiy Filtres à huile de rechange pour Sea-Doo Bombardier John Deere KN-556, 420956741, 711956741 Is it ok you think
@maritimegoalie3 жыл бұрын
I was so worried you were going to burn yourself on that hot oil....
@PovertyPointCustoms3 жыл бұрын
It was very hot!
@maritimegoalie3 жыл бұрын
PovertyPointCustoms like you!
@mfacote Жыл бұрын
And can 1 send you a picture of my motor
@PovertyPointCustoms Жыл бұрын
Sure, you can send it to my Instagram povertypointcustoms in a DM message
@billlentz1113 Жыл бұрын
Look in your owners manual. Recommends 10w40 all year. Page 96 owners manual DO NOT USE FULL SYNTHETIC OR BLEND. OTHER THAN BOMBARDIER BRAND.
@PovertyPointCustoms Жыл бұрын
We used the 0w40 as it is used to plow when it's-20 here