Short video tutorial of how to change the valve springs and seals on a SBF engine. Hope you learn something!
Пікірлер: 22
@CarsFoodWeed2 жыл бұрын
Nice vid, don't worry about rushing, youtubes love 20 minutes videos
@66i6mustang3 Жыл бұрын
Haha Thanks! I don't do it for the algorithm money, just trying to show a frustrated or eager to start individual how to do it in no-time-flat! Brevity is key
@Ricardo_Wade Жыл бұрын
Good video exactly what i needed to get job done on these ebay aluminum heads
@sheslikeheroin16612 жыл бұрын
This is insanely helpful. Good shit!
@66i6mustang3 Жыл бұрын
Glad I could help!
@rustingparts2 жыл бұрын
What a fantastic video great job!
@66i6mustang3 Жыл бұрын
Thank you!
@BrandondoodGames3 жыл бұрын
Great video sir!
@66i6mustang3 Жыл бұрын
Thank you for watching! Hope it was helpful
@Bigthingz12 Жыл бұрын
Great vid Can this be done with the motor still in the car? Approximately how much would a qualified mechanic charge for this?
@66i6mustang3 Жыл бұрын
Yes it can, and people prefer and do it this way because you don't have to change the headgasket. You just have to be mindful of the engine cycle so the piston you are taking the springs out of isn't at the bottom of its stroke or the valve will fall in the cylinder hole. This can be done by shooting compressed air into the intake and exhaust ports respectively. Or have a buddy with a third hand hold it with rubber grips (dont scratch it!)
@williammason35983 жыл бұрын
What is the part number of the seals and where did you buy them?
@66i6mustang3 Жыл бұрын
I bought mine on rockauto! They are Felpro SS72891
@bonezshakergarage3 жыл бұрын
Great detailed video.
@66i6mustang3 Жыл бұрын
Thanks!
@martingagne3673 жыл бұрын
Thank you very helpful!
@Andre-gt3ip2 жыл бұрын
Can I do this without removing the cylinder head from the block?
@murraymadness46742 жыл бұрын
yes, need to be careful and put the piston up so the valve doesn't fall down.
@bodhijohnson28032 жыл бұрын
I’d reccomend you do it with the head off so you can lap the valves. It’s stupid easy and free hp
@66i6mustang3 Жыл бұрын
Yes it can, and people prefer and do it this way because you don't have to change the headgasket. You just have to be mindful of the engine cycle so the piston you are taking the springs out of isn't at the bottom of its stroke or the valve will fall in the cylinder hole. This can be done by shooting compressed air into the intake and exhaust ports respectively. Or have a buddy with a third hand hold it with rubber grips (dont scratch it!)
@DeAngeloFernandez3 жыл бұрын
who makes that valve compressor tool?
@murraymadness46742 жыл бұрын
you can rent them at oreilly's. I personally use a C clamp and grind off the center to make the end like a fork, so it will clamp the spring all the way down. Not possible if you do this with the head still on the engine, then you need that tool shown.