How to check the headlight cable path, cent, horn, yamaha jupiter mx 135, 150. The first step that must be checked is the output path from the road spool that leads to kiprok: 1. Red line yellow wire as the current from the road spool that goes to kiprok as a lamp lighting path that is processed by kiprok and enters again to the far near switch. 2. The black cable as the time for kiprok must be sure to stick to the motor body. 3. The white cable is the charging current from the spool going to the kiprok and the red cable is coming out as the battery charger plus. 4. Red wire as 12 volt battery current that goes into the ignition. As for the line of lights, pennies, horns are. 1. The white line brown wire as the 12 volt battery line after the ignition is turned on and will go directly to the turn signal switch, horn, brake light. 2. Black wire as mass or ground make sure it must be attached to the motor body. 3. Plain brown cable as a 12 volt battery current that goes out to the left turn signal after the switch is pressed to the left. 4. Plain dark green cable as a 12 volt battery current that comes out to the right turn signal after the switch is pressed to the right. 5.Ping cable as horn line. 6. Blue black wire as the lighting current from the kiprok that goes to the near and far switch. 7. The light green wire is the current of short-range lamp lighting that goes directly to the main lamp spot or pit after the close-range switch is pressed. 8. The yellow wire is the current of the remote lamp which goes directly to the main lamp spot or pit after the remote switch is pressed. Thank you to all #SUBSCRIBER# wherever you are, hopefully the knowledge is useful. Please #SUBSCRIBE LIKE COMMENT AND SHARE# #SIDIK NURYADEN CHANNEL# If you have questions, you can write them in the comments. Tel/WA: 085863491419. Thank you very much.