carb kits amzn.to/3qh5f45 check out my beautiful girlfriends etsy store www.etsy.com/s....
Пікірлер: 32
@FranklinFisher-y5d17 күн бұрын
Thanks for the guidance, I've got a 50hp with the same basic setup. Going to clean the carbs as instructed and will see how it works.
@charlesoverton Жыл бұрын
Nice to see back working on carburetor.
@smallengineguys Жыл бұрын
yeah ill be doing it a little here and there but i am a tech at the nissan dealership now. i sold the mower shop and moved to the country bought a 3bed house on 3 acres on a lake. i call it my semi retirement. went from 200k to 80 so its been an adjustment.
@user-qw2uh2tw2g9 ай бұрын
thanks for the info, i just used straight muriatic acid did the job ty
@CluelessEngineer Жыл бұрын
I have pretty much the same motor. Appreciate the bit about the rubber swelling up from carb cleaner. I'm going to remove that seal first if it wont break on me.
@smallengineguys Жыл бұрын
Good luck!
@CluelessEngineer Жыл бұрын
@@smallengineguys so I just did everything and put it all back together. Fired up in a barrel of water no problem. Is it normal that the engine isn't peeing? Is it only supposed to spray water out after it gets hot? Or is it always supposed to spray water out when it's running?
@smallengineguys Жыл бұрын
always sprays. sounds like bad impellor.
@CluelessEngineer Жыл бұрын
@@smallengineguys turns out it was a wasp sitting in the hole so that's fixed. After carb clean the motor runs for a minute or two and then dies by itself. It starts can barely handle idling and if I push the throttle arm it'll rev up then die as soon as it can. I'm thinking bad fuel pump because gas been sitting in it for 2 yrs. Any ideas?
@smallengineguys Жыл бұрын
@@CluelessEngineer sounds about right. If you prime it up again does it run again?
@rockynymia2 ай бұрын
What’s that acid you were using
@bradleymcwillie52256 күн бұрын
I don’t see the link or a reply on what acid this is. Any help is appreciated just got them apart and want to get her back running for next weekend!
@dabbotube3 ай бұрын
Is there a video on how to access the fuel filter on this outboard, I can’t seem to find one
@boatdude127 ай бұрын
Thanks for the video
@shanehankins40513 ай бұрын
Thanks bother
@smallengineguys3 ай бұрын
Welcome
@neonnight34609 Жыл бұрын
What is that solution, i cant seem to find it and don't see a link
@SatashMitusinghАй бұрын
How do you set the timing on the 50hp yamaha
@smallengineguysАй бұрын
2 stroke? its the flywheel key that sets the timing.
@josephhaigh10083 ай бұрын
Hey does anyone know the name of the part that sits below the fuel hoses, and screws onto the bottom Carb? It’s some kind of linkage and I think it’s missing a piece that connects through a square hole.
@chanlerblackmon53052 ай бұрын
That would be your choke knob
@paulwallace22633 ай бұрын
No oil tank? Did you remove it and mix?
@smallengineguys3 ай бұрын
It wasnt there. This was a customer.
@Shornandkenny24 күн бұрын
Oil injection delete is the best!
@osamaodeh394011 ай бұрын
Does anyone know what the gold solution is?
@smallengineguys11 ай бұрын
amzn.to/3PhXqVW
@smallengineguys11 ай бұрын
amzn.to/3PhXqVW
@harrispilton66932 ай бұрын
next time get a better set of tools man. lol
@smallengineguys2 ай бұрын
ill do this shit with 2 sticks and a rock
@Shornandkenny24 күн бұрын
I'm betting this guy tunes circles around you.
@smallengineguys24 күн бұрын
@@Shornandkenny i tuned circles around him at 5 in dads shop.
@Shornandkenny24 күн бұрын
@@smallengineguys I mean you tune circles around this asshat my brother.