Thanks for the easy to follow video. I cleaned my MAP sensor with your assistance!

i dip them in nail varnish remover(acetone), your videos are much appreciated, i have the same car with 300k km, thanks

Now i wait for an EGR valve cleaning video. 😊

My one was completely black. you couldn't even see the gaps. Thanks alot.

0:16 I actually lost my turtle...

matori čarape su ti vrh :D

My friend, when I drive on the highway, I get error number 84 and the car enters the safe situation. Do you have a piece of advice that I have to work with or a video that I have to watch? Thank you.

Thank you arkadas 👍 My map Sensor was very very dirty!??!!

Great video very descriptive

Nice, thank you

My sensor won't come out what might be the problem. Could I lever it with a screwdriver or would that be dangerous

Hello I can not recognize the brand of spray can u tell me what kind of spray you use for cleaning the map sensor

what product do you use to clean the sensor?

Koji ti je ovo sprej za ciscenje. Jel VD sprej ili neki drugi. Hvala

Hi, i just checked my 2010 meriva 1.7cdti map sensor values with Wurth Wow and delphi softwares . Off engine -100kpa , at idle 99kpa. Map sensor dead? Have a higher diesel consumption .

Brother pls help my fuel pumb is not priming .And the relay clicks & fuel pump works only when the the key is fully turned to start position ......what is the reason for this delay in clicking of relay ......is my map sensor clogged.....help me out pls.....opel corsa classic 2005 ...

Thank you Bolshoi Spasibo.

Dobry jesteś.

Bedankt!!

afterwards, the grass will not grow !! ;))

What cleaning product are you using??

Thank you!

Thanks for video.

Well done

I cleaned it with brake cleaner. And now it feels clogged on 2nd gear

Thank you 😊😊😊😊

Hello, My problem was (now is always) the engine speed needle it's not stable. After clean the map sensor it was better and stable for the engine. Few killometers the problem was come back. Do yo know if i need change the map sensor ? Or it's my injectors are bad ? Thank you for your job.

poštovani Zlita , odličan video! imam jedno pitanje; Imam istu Astru kao i ti , pojavio mi se problem sa dosta nemirnim radom u leru (172.000km) a ustanovilo se da prva dizna (denso) ne radi dobro. Istu sam reparirao ostale su provjerio te postavio nove kodove na sve 4 dizne. Auto sada radi sasvim normalno ali mu je ostala uključena lampica (auto sa ključem) koju je nemoguće poništiti sa Bosch dijagnostikom. da li moram ići u ovlašteni Opel servis ili imaš neko drugo rješene ? hvala na odgovoru lp

Good job

Hi, what tool are you using to unscrew the bolts?

👍

how many kilometers will be cleaned?

Buraz pricas ko pravi englez 😂😂

Hi,although i didnt remove the MAP as i didnt have right screw driver at the time ,i removed the sensor adaptor and put back properly.Next day on starting engine light came on .i cleared the code with torque pro.I plan to clean the MAP sensor,shall i disconnect the negative terminal of battery before removing MAP next time.code was P0108 high input ,your advice is appreciated.thanks

What spray did you use..

With what spray did you clean the sensor?

You don't need to spray that much?

I clean it. It was verry dirty at 184000 kilometres

dont lose no turtles

WHAT PROBLEMS MAKES THAT SENSOR TO THE CAR ?

Not on the grass man!!! this goes in the ground and after in the water that your kids will drink!

How long he took the connectors off 😂😂😂😂

But it's not well done to throw the spray liquid to the ground!!! It's so polluting!!!

такого бедного немца не видел ))) в порванных ботасах ходит.

My friend, when I drive on the highway, I get error number 84 and the car enters the safe situation. Do you have a piece of advice that I have to work with or a video that I have to watch? Thank you.